Technical data

Vario II series
Function menu
06/10
Operating manual
61
8.5 Print mode
Press key to access the function menu.
Press key
as long as you arrive at the 'Print Mode' menu.
Press key
to select the menu.
Label type:
Generally adhesive labels are set. Press key
to select continuous
labels. If the menu label length/gap length contains a gap value, this
value is added to the label length.
Press key
to arrive at the next menu item.
Flip label:
The axis of reflection is in the middle of the label. If the label width
was not transferred to the printer, automatically the default label width
i.e. the width of the printhead is used. It is recommended to use labels
with the same width as the printhead. Otherwise this can cause
problems in positioning.
Press key
to arrive at the next menu item.
Rotate label:
According to standard the label is printed ahead with a rotation of 0°. If
the function is activated, the label is rotated by 180° and printed in
reading direction.
Press key
to arrive at the next menu item.
Transfer ribbon control:
Examination if the transfer ribbon roll is to end or if the ribbon was torn
at the unwinding roll.
Off: The ribbon control is deselected, i.e. the printer continues without
an error message.
On: The ribbon control is selected, i.e. the current print order is
interrupted and an Error Message appears at the printer display.
strong sensibility: The printer reacts immediately to the end of the
transfer ribbon.
weak sensibility: The printer reacts at approx. 1/3 more slowly to the
end of the transfer ribbon.
Press key
to arrive at the next menu item.
Dispenser mode:
To operate the printer in dispensing mode a print order has to be
started and the printer has to be in 'waiting' mode.
By means of key
you can switch to the next operating mode (see
chapter 9.2 Dispenser, on page 76).