Technical data

Vario II series
Additional information
06/10
Operating manual
113
Peel off:
After printing the label it is driven into the dispensing
offset and there waited. When releasing a new start
signal (IO dynamic) then the next label is
immediately printed. Because of the fact that the
label is already in the offset, the label is only printed
from beginning of offset position, i.e. at the definition
of label an accordingly large range must be left free
at the top margin of label, because these data are
otherwise not printed.
Cutter:
This is the same function as for 'backfeed standard'
as it is always backtracked after cutting immediately
to the beginning of label.
Tear off
edge:
After printing the last label of a print order it is driven
into the tear-off offset. When starting a new print
order, the next label is immediately printed. Because
of the fact that the label is already in the offset, the
label is only printed from beginning of offset position,
i.e. at the definition of label an accordingly large
range must be left free at the top margin of label,
because these data are otherwise not printed.
If a following print order is available before driving
into the tear-off offset, then it is not driven into tear-
off offset but the following label is directly printed.
Peel off:
After printing the label, during driving into dispensing
offset the following label is 'pre-printed', if this is
already available (generated). When releasing a new
start signal (IO dynamic) the already 'pre-printed'
label is printed to the end and when driving into the
dispenser offset the following label is again 'pre-
printed'. In case the following label is not yet
available or at the last label of a print order, the
dispenser offset is driven as until now, and then for
the next label before printing the backfeed to the
beginning of label is executed.
Cutter:
After printing the label, during driving into the cutter
offset the following label is 'pre-printed', if this is
already available (generated). After the cut it is not
backtracked but the already 'pre-printed' label is
printed to the end and when driving into the cutter
offset the following label is again 'pre-printed'. If the
following label is not yet available or at the last label
of a print order, the cutter offset is driven as until
now, then cut and afterwards the backfeed to the
beginning of label is executed.
Tear off
edge:
This is the same function as for 'backfeed standard'
as it is only driven into the tear-off offset at the last
label of a print order, if no following print order is
available.
No backfeed
Optimised backfeed