User guide

17
Programming radio triggers
Up to nine radio triggers or other radio-alarm transmitters, e.g. smoke
detectors, can be programmed for the carephone.
Programming radio transmitters:
• Hold down the green button for approximately four seconds until the
green “On” light starts to flash.
• Press the radio trigger. Once the carephone has received the radio
signal, you will hear a distinct tone signal.
• Confirm by pressing the red button on the carephone.
Check radio coverage
This should always be done on installation.
• Hold down the green button for approximately four seconds until the
green “On” light starts to flash.
• Press the radio trigger. The built-in speaker will produce a tone
signal on successful reception. Repeat this in all areas where the
alarm needs to operate.
General information
• If the telephone line is not working, no alarm can be sent.
• The carephone should be connected to the master telephone socket in
the home.
• In order for an alarm to be sent, at least one alarm receiver/response
centre needs to be programmed.
• The carephone must not come into contact with water or any other
liquid.
• In case of battery alarm, the batteries should be replaced as soon as
possible in order for the alarm to function correctly.
• Used batteries should be disposed of in an environmentally-responsible
manner.