User`s guide

4-2 2G8647 2010-11-04
Adding a Modality and Configuring Modality Image Quality
The message appears: "This modality is recognized as below, for
which recommended image quality parameters are available. Do
you want to use them?"
7. Is the modality type, manufacturer, and model correctly identified?
8. Touch:
• Ye s
• OK
9. At the prompt, send another image from the modality to the Imager.
10. After the image is printed, touch OK.
11. Is the image quality from step acceptable?
Yes No
a. Touch Ye s.
The message "This will reset
all modality parameters! Are
you sure?" will appear.
b. Continue with step 8.
a. Touch No.
b. Follow the on-screen prompts
to select the modality
manufacturer, type, and
model.
c. Touch Apply new defaults.
The message "This will reset
all modality parameters! Are
you sure?" will appear.
d. Continue with step 8.
Yes No
a. Touch:
OK
Exit
b. At the Backup configuration
screen, touch Ye s .
c. At the Configuration backed
up screen, touch OK.
Configuration is complete.
The Main Screen will appear.
a. Touch:
OK
Exit
b. At the Backup configuration
screen, touch No.
The Main Screen will appear.
c. You will have to do
“Configuring Modalities
Manually” on page 4-3.