User manual

7
GB
“Wellness” +030220571 - rel. 3.0 - 01.10.2007
installeruserservice
1. INTRODUCTION AND ASSEMBLY
1.1 humiSteam Wellness (UEW*)
Range of CAREL isothermal immersed electrode humidi ers with liquid
crystal display for the control and distribution of steam in steam baths.
Models available (identi able from the code shown on the product):
UE001, UE003, UE005, UE008, UE009, UE010, UE015, UE018: smaller
models with steam production capacity up to 18 kg/h, water
connections under the base of the humidi er;
UE025, UE035, UE045, UE065: larger models with steam production
capacity from 25 to 65 kg/h, water connections on the side of the
humidi er.
1.2 Dimensions and weights
Models UE001 to UE018 Models UE025 to UE065
Fig. 1.a
UE001…
UE008
UE009…
UE018
UE025…
UE045
UE045**…
UE065
dimensions
(mm)
A 365 365 545 635
B 275 275 375 465
C 620 712 815 890
weights
(kg)
packaged 16 20 39 51
empty 13.5 17 34 44
installed* 19 27 60.5 94
Table 1.a
*= in operating conditions  lled with water;
**= 230 Vac model
1.3 Opening the packaging
make sure the humidi er is intact upon delivery and immediately
notify the transporter, in writing, of any damage that may be due to
careless or improper transport;
move the humidi er to the site of installation before removing from
the packaging, grasping the neck only from underneath the base;
open the cardboard box, remove the protective material and remove
the humidi er, keeping it vertical at all times.
1.4 Positioning on the wall
the unit is designed to be mounted on a wall that is strong enough to
support the weight in normal operating conditions (see Wall-mounting
below). Models UE025 to UE065 can stand on the  oor;
to ensure correct steam distribution, position the humidi er near the
point of steam distribution;
make sure the humidi er is level, allowing the minimum clearances
(see Fig. 1.b) for maintenance operations.
Important
Important: during operation the metal casing heats up and the
rear part resting against the wall may reach temperatures in
excess of 60 °C.
•
•
o
o
o
•
•
•
Distance from the walls
Models UE001 to UE018 Models UE025 to UE065
Fig. 1.b
1.5 Wall-mounting
Fit the humidi er on the wall using the support bracket and the screw kit
supplied (for the dimensions in mm see Fig. 1.d).
Assembly instructions:
unscrew the wall bracket from the humidi er bracket;
fasten the wall bracket (see Fig. 1.c), checking horizontal position
with a spirit level; if installed on a masonry wall, the plastic anchor
plugs (dia. 8 mm) and screws (dia. 5 mm x L= 50 mm) supplied can
be used;
hang the appliance to the bracket using the slot on the top edge of
the rear of the appliance;
secure the appliance to the wall through the hole in the centre on
the rear of the unit. For the weights and dimensions see Tab.1.a.
Models UE001 to UE018
X
bracket
Models UE025 to UE065
X
bracket
Fig. 1.c
1.
2.
3.
4.