Specifications

AIREFRIG AUSTRALIA PTY LTD
ALL PRICES ARE EXCLUSIVE OF GST
RECOMMENDED LIST PRICES
SUBJECT TO CHANGE WITHOUT NOTICE
A.B.N. 95 008 761 573
EFFECTIVE MARCH 2014
329
CAREL ELECTRONIC CONTROLLERS
PHASE SEQUENCE CONTROLLERS
RSF Phase Sequence Controller
Airefrig Part Number
RSF077D000
Power Supply
220 Vac
Changeover contact
output relay
240 Vac - 8A
Response Time
80 ms
Consumption
0.8 VA
Dimensions
2 DIN modules (87 x 60 x 36 mm)
Index of protection
IP40
Mounting
DIN rail
Controller pricing
Airefrig Part Number
RSF077D000
List Price - Ex GST
$142.83
ANTI SWEAT HEATER CONTROL
ACC Anti-sweat Heater Control
Airefrig Part Number
ACC0082100
Power Supply
230 Vac
Analogue Outputs
1 ph control, 0 to 230Vac single-ph, 8A
Analogue Inputs
1 x 0 to 10V, 2 x NTC
Digital Inputs
1
Serial Outputs
1 standard RS485
Dimensions
140 x 135 x 90 mm
Index of protection
IP43
Controller Pricing
Airefrig Part Number
ACC0082100
List Price - Ex GST
$565.41
Accessories for ACC
Airefrig Part Number
Description
List Price
Ex GST
NTC060WG00
Glass temperature probe -50 to +105 °C
$76.68
DPWC115000
Wall mount temperature and humidity probe 0 to 50°C (NTC) & 10 to 90 %rH (0-10V)
(replaces ASWC115000)
$334.74
FLOOD DETECTION MODULE
FLO Flood Detection Devices
Airefrig Part Number
Description
List Price Ex GST
FLOE000010
Flood controller 24V DIN rail mount
$288.81
FLOR000000
Flood sensor tape (Roll of 25m)
$703.05
FLOS000000
Flood sensor
$71.01
This electronic device measures the correct
sequence and presence of phases L1, L2, L3 at
input. It is fitted with an output relay with
changeover contacts.
The controller has the following characteristics:
Dewpoint calculation
Manual offset setting
Programmable digital input (alarm or enabling signal)
Master / Slave function
Serial interface for connection to supervisory systems
or local network
ACC is a microprocessor controller that is used to prevent the formation of condensate on cold surfaces, such as display case
windows, measuring the dewpoint and consequently heating the cold surface so as to maintain the temperature above the
dewpoint. Heating is performed by controlling the voltage applied to door heaters, using phase control integrated into the device.
The FLOS* flood detector is an electronic device complete with sensor probe designed to detect the presence of water and
consequently signal the alarm. The device is typically installed inside the electrical panel, while the probe should be located in
the zone being controlled.