Service manual

8 Infant Flow
®
SiPAP
675-120 Revision D May 2005
Notices
Copyright Notice
Copyright © 2004 VIASYS Healthcare, Respiratory Care, California.
This work is protected under Title 17 of the U.S. Code and is the sole property of the
Company. No part of this document may be copied or otherwise reproduced, or
stored in any electronic information retrieval system, except as specifically permitted
under U.S. Copyright law, without the prior written consent of the Company. For
more information, contact:
World Headquarters European Office
1100 Bird Center Drive VIASYS Healthcare
Palm Springs, CA 92262-8099 Leibnizstrasse 7
U.S.A. D-97204 Hoechburg
Phone: (760) 778-7200 Germany
(800) 328-4139 Phone +49 (0) 931 4972 – 0
Fax: (760) 778-7274 Fax:+49 (0) 931 4972 –423
www.VIASYSCriticalCare.com
Trademark Notices
Infant Flow
®
and SiPAP are trademarks of VIASYS Healthcare, Respiratory Care in
the U.S. and some other countries. All other brand names and product names
mentioned in this manual are trademarks, registered trademarks, or trade names of
their respective holders.
EMC Notice
This equipment radiates and is susceptible to radio frequency energy. If not installed
and used in accordance with the instructions in this manual, electromagnetic
interference may result. The equipment has been tested and found to comply with
the limits set forth in BS EN60601-1-2 for Medical Electrical Equipment Part 1-2:
General requirements for safety-collateral standard. Electromagnetic compatibility –
requirements and tests. These limits provide reasonable protection against
electromagnetic interference when operated in the intended use environments (e.g.
hospitals) described in this manual.
This device is also designed and manufactured to comply with the following
standards;
Safety: UL 60601-1: 2003 Medical Electrical Equipment, Part 1: General
Requirements for Safety.
CAN/CSA C22.2 No 601.1-M90, Medical Electrical Equipment - Part
1: General Requirements for Safety including C22.2 No. 601.1S1-94
(IEC601-1, Amendment 1:1991) Supplement No. 1-94 to CAN/CSA
22.2 No. 601.1-M90