Service manual

Service Manual 71
675-120 Revision D May 2005
Removal and Fitting of Case Bleed Filtered
Restrictor
Refer to Figure 18.
Removal
1 Remove the case and loosen the clamp securing the restrictor to sheet metal.
2 Note restrictor flow direction, then remove the case bleed filtered restrictor (3)
from the 4mm tube.
3 Discard the case bleed filtered restrictor (3).
Fitting
1 Install the new case bleed filtered restrictor (3) to the tube in the proper
orientation.
2 Re-secure the restrictor to the sheet metal.
3 Install the case.
Figure 18 Water Trap Filter Removal/Fitting