Installation & Assembly

Active Ingredient:
Silver Chloride ............ 0.5%
Other Ingredients: .... 99.5%
Total: .........................100.0%
EPA Reg. No. 53735-11
EPA Est. No. 71209-AZ-001
KEEP OUT OF REACH OF CHILDREN
CAUTION
It is a violation of Federal Law to use this product in a manner
inconsistent with its labeling.
EPA Reg. No. 53735-14
EPA Est. No. 71209-AZ-001
KEEP OUT OF REACH OF CHILDREN
DANGER
It is a violation of Federal Law to use this product in a manner
inconsistent with its labeling.
Directions for Use: For use in hot tubs up to 600 gallons. Use with
the @ease SmartChlor Cartridge. Ensure all hot tub equipment is
working properly. Operate the pump and filter for at least 3 hours
per day. Clean filter following manufacturer’s directions. May be
used with a previously filled hot tub unless it was sanitized with
bromine. Then drain and fill the hot tub with fresh water.
Start-up: Balance the water according to the water balance
guidelines with pH between 7.2 – 7.8 and total alkalinity at 80
to 120 ppm. Establish a free chlorine residual of 0.5 to 1.0 ppm
in the hot tub with Frog Jump Start start-up shock or an EPA
approved hot tub chlorine shock following the directions for that
product. When using other products as outlined in directions for
this product, always follow directions on those products.
To assemble:
• Remove outer packaging
• Peel off protective seal from the flat part of the @ease
SmartChlor Cartridge
• Align arrows on blue mineral cartridge and silver chlorine
cartridge
• Push together and twist to lock
• Set the dial on the chlorine cartridge (see Setting Chart
in manual)
• Place entire system in the hot tub water.
• Shock the hot tub when replacing an @ease SmartChlor
Cartridge or once a month
Replacing the Cartridges: Replace the @ease SmartChlor
Cartridge when the system flips over. Follow label directions care-
fully. After four months or when draining and refilling the hot tub,
replace the @ease System.
Directions for Use: For use in hot tubs up to 600 gallons. Use
with the @ease SmartChlor Cartridge. Ensure all hot tub equip-
ment is working properly. Operate the pump and filter for at least 3
hours per day. Clean filter following manufacturer’s directions. May
be used with a previously filled hot tub unless it was sanitized with
bromine. Then drain and fill the hot tub with fresh water.
Start-up: Balance the water according to the water balance
guidelines with pH between 7.2 – 7.8 and total alkalinity at 80
to 120 ppm. Establish a free chlorine residual of 0.5 to 1.0 ppm
in the hot tub with Frog Jump Start start-up shock or an EPA
approved hot tub chlorine shock following the directions for that
product. When using other products as outlined in directions for
this product, always follow directions on those products.
To assemble:
• Remove outer packaging
• Peel off protective seal from the flat part of the @ease
SmartChlor Cartridge
• Align arrows on blue mineral cartridge and silver chlorine
cartridge
• Push together and twist to lock
• Set the dial on the chlorine cartridge (see Setting Chart
in manual)
• Place entire system in the hot tub water.
• Shock the hot tub when replacing an @ease SmartChlor
Cartridge or once a month
Replacing the Cartridges: When the system flips over, replace
the @ease SmartChlor Cartridge by rotating the two cartridges
until the arrows align and pull apart. Drain the water from the
old @ease SmartChlor Cartridge and shake slightly to see if it
is empty. Follow disposal instructions and replace with a new @
ease SmartChlor Cartridge. Do not discard or recycle cartridge if
a small amount of chlorine remains. Place in the hot tub to float
on its own until completely empty
• Keeping the pH in the proper range of 7.2 to 7.8 will allow the
@ease SmartChlor Cartridge to keep the free chlorine level
between 0.5 and 1.0 ppm with little adjusting.
• With the @ease SmartChlor Cartridge less shocking is required
because it maintains a consistent level of sanitization even
when people enter the hot tub.
REENTRY into treated hot tubs is prohibited above levels of 5 ppm available
free chlorine as measured by a suitable test kit due to risk of bodily injury.
@ease™ Mineral Cartridge @ease™ SmartChlor™ Cartridge
Active Ingredients:
1.3-dichloro-5, 5-Dimethylhydantoin .........81.1%
1.3-dichloro-5-ethyl-5-methylhydantoin ....16.1%
Other Ingredients: ........................................... 2.8%
Total: ...........................................................100.0%