Installation & Assembly

Hot Tub Start Up
• Always drain and refill hot tub at least every
4 months. If previously using bromine and
switching to @ease SmartChlor, you must drain
and refill your hot tub first. If previously using
dichlor you may convert to SmartChlor without
having to drain the hot tub.
• Clean and replace filter cartridges when
dirty (Follow manufacturer’s instructions).
• Use @ease™ Test Strips included in the package to balance your
pH, Total Alkalinity and Calcium Hardness according to the Water
Balance Guidelines. This hot tub system will maintain the free
chlorine level of 0.5 to 1.0 ppm. pH is affected by bather load,
chemical usage, evaporation and the make-up of your source
water.
• Heat water to recommended temperature before using
cartridges.
• Very Important! Before using cartridges, establish an initial
residual of 0.5 - 1.0 ppm free chlorine with FROG
®
Jump
Start™ start-up shock, included in this package, that quickly
dissolves with an effervescent fizzing action – one packet per 500 gallons.
Regular Hot Tub Care
1. Run filtration system as recommended by your hot tub
manufacturer or at least 3 hours per day.
2. Periodically test the water for pH, Total Alkalinity, Calcium
Hardness and chlorine levels with the precise @ease™ Test
Strips that include special directions for using with these
products. The @ease SmartChlor Cartridge forms a chlorine
reserve that is measured as total chlorine on a standard
test strip/kit. This chlorine reserve readily shifts to free chlo-
rine as needed to maintain our recommended low level of
chlorine. Based on average hot tub usage, chlorine will last
about 3-4 weeks for hot tubs of 400 gallons.
3. Shock the hot tub with a non-chlorine shock when
you replace the @ease SmartChlor Cartridge or once a
month or if the water looks cloudy. With @ease SmartChlor
Cartridge, far less shocking is required compared to stan-
dard water treatments that require weekly shocking or
shocking after every use.
4. Replace the @ease SmartChlor Cartridge when the
system flips over. Replace the complete @ease Floating
System every four months or when draining and refilling
the hot tub. Even if, upon shaking the mineral cartridge, it
appears there is spent media left inside, once wetted the
time released minerals in the cartridge are effective up to
four months.
NOTE: This product may be removed from the hot tub
when in use. Lift out of the water and let drain into the
hot tub. Then place on any surface that is not susceptible
to bleaching from the chlorine. Remember to replace the
product once exiting the hot tub.
Replacing the @ease SmartChlor Disinfectant Cartridge
When the product is almost empty, it will slowly flip over giving
you notice that it’s about time to replace the @ease
SmartChlor Cartridge. If it stays on its side longer than a day
or two, pull unit out of the water and let it drain. Reset it in
the water to see if it flips completely.
When it completely flips over replace by rotating the two
cartridges until the arrow on the @ease SmartChlor Chlorine
Cartridge aligns with the unlock symbol on the @ease
Mineral Cartridge and pull apart. Follow "Using the @ease
Floating System" directions for attaching a new chlorine cartridge.
Do not remove the @ease SmartChlor Cartridge until the system has
completely flipped. If the chlorine cartridge still contains a small
amount of chlorine after the system has flipped over, place in the hot
tub alone until completely empty. Do not allow the @ease SmartChlor
Cartridge to sink to the bottom or bleaching of the hot tub surface could
occur. When completely empty, discard in trash or offer for recycling.
King Technology, Inc. 530 11th Ave S, Hopkins, MN 55343
www.KingTechnology.com Patents: www.KingTechnology.com/IP 20-48-0192 553121543R2N
Note: Free Chlorine levels are reduced up
to 75%* when using FROG minerals
Water Balance Guidelines
pH: 7.2 – 7.8
Total Alkalinity: 80 - 120 ppm
Calcium Hardness: 150-250
Total Dissolved Solids: <1500
Free Chlorine: 0.5-1.0 ppm
Welcome to Fresh Mineral Water® with SmartChlor™ Technology courtesy of
FROG®. This hot tub water care system+ destroys bacteria to keep your hot
tub clean with less work and up to 75% less chlorine.*
There are two cartridges – the top one holds our patented mineral formula
while the bottom one has a different kind of chlorine that is smart about
when it’s needed and when it’s not. Simply connect the two cartridges and
toss into the hot tub. Everything is pre-filled and contained for no mess, no
guess and no stress hot tub care. The best part is it flips over when it’s time
to replace the chlorine cartridge.
Register your @ease™ Floating Sanitizing System at KingTechnology.com
Floating Sanitizing
System Operation
Instructions
+ @ease System consists of the FROG minerals silver chloride and carbonate used with 0.5 ppm of @ease SmartChlor Cartridge.
The @ease Mineral Cartridge must be used in conjunction with the @ease SmartChlor Cartridge (EPA Reg. No. 53735-14).
* Compared to the minimum ANSI recommended chlorine level of 2.0 ppm for a hot tub.
This is not a toy. For sanitizing hot tubs only!
3. Once set, simply toss it into the hot tub.
4. Follow regular hot tub water care procedures below.
1. Remove outer packaging from
both the mineral and chlorine
cartridges and while holding the
@ease SmartChlor Cartridge over
the hot tub, remove the protec-
tive seal and allow any loose
particles to fall into the water.
Bring the two cartridges together
and line up the arrows.
Push together and twist to lock.
2. Twist the dial on the bottom
cartridge to the setting number
for your hot tub size (see chart).
Using the @ease Floating System
Setting # on
the @ease
SmartChlor
Cartridge
O
F
F
1
2
3
4
N
o
t
A
T
o
y
R
e
p
l
a
c
e
C
a
r
t
r
i
d
g
e
w
h
e
n
f
l
o
a
t
i
n
g
u
p
@ease Setting Chart
Gallons Setting #
200 1
300 2
400 2
500 3
600 4
N
o
t
A
T
o
y
TOP HALF
@ease
Mineral
Cartridge
BOTTOM
HALF
@ease
SmartChlor
Cartridge