User`s manual
Intel-GE Care Innovations™ QuietCare® System
Hardware Maintenance Guide
Document: DHF-3756 Page 53 of 60
Revision: 1.0 Effective: January 29, 2012
Regulatory Statements
This QuietCare — Dial-Up base station equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other
information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be provided
to the telephone company.
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord
and modular plug is provided with this product. It is designed to be connected to a compatible modular jack
that is also compliant. See installation instructions for details.
If trouble is experienced with this base station equipment QC100103, for repair or warranty information, please
contact Intel-GE Care Innovations LLC at1-855-885-CARE(2273). If the equipment is causing harm to the
telephone network, the telephone company may request that you disconnect the equipment until the problem
is resolved.
According to the FCC, only Care Innovations is allowed to service the modems. Contact Care Innovations for
an RMA number. DO NOT RETURN MATERIAL WITHOUT AN AUTHORIZED RMA NUMBER.
Connection to party line service is subject to state tariffs. Contact the state public utility commission, public
service commission or corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of
this QuietCare — Dial-Up QuietCare does not disable your alarm equipment. If you have questions about
what will disable alarm equipment, consult your telephone company or a qualified installer.
UserInformation
Common FCC (ACTA) Part 68—The Federal Communication Commission (FCC) has established rules,
which permits this device to be directly connected to the telephone network. If this device is malfunctioning, it
may also be causing harm to the telephone network. This device should be disconnected until the source of
the problem can be determined and until repair has been made. If this is not done, the telephone company
may temporarily disconnect service. The telephone company may make changes in its technical operations
and procedures. If such changes affect the compatibility or use of this device, the telephone company is
required to give adequate notice of the changes. If the telephone company requests information on what
equipment is connected to their lines, inform them of the following:
a) The telephone number and the device it connected to.
b) The Ringer Equivalence Number (REN): 0.0B
c) The device uses an RJ11 type jack.
d) The FCC Registration Number ~ US: LIGMM00BQC200401
The REN for the modem is part of the product identifier that appears on the product label.
[US: LIGMM00BQC200401]. The digits shown after MM are the REN without the decimal point. (e.g., 00 is a
REN of 0.0) The REN is used to determine the number of devices that may be connected to the telephone
line. Excessive REN on a telephone line may result in devices not ringing in response to an incoming call. In
most, but not all areas, the sum of the REN should not exceed five (5.0). To be certain of the number of
devices that may be connected to a line, as determined by the total REN, contact the telephone company.
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or any
other electronic device, including fax machines, to send any message unless such message clearly contains in
a margin at the top or bottom of each transmitted page or on the first page of the transmission, the date and
time, it is sent and an identification of the business or other entity, or other individual sending the message and
the telephone number of the sending machine or such business, other entity, or individual. The telephone