User`s manual

Intel-GE Care Innovations™ QuietCare® System
Hardware Maintenance Guide
Page 52 of 60 Document: DHF-3756
Revision: 1.0 Effective: January 29, 2012
Non‐DrywallMountingProcedure
1. Position the bracket at the selected location.
2. Apply a piece of VHB tape from the hardware kit to the back of the bracket and press the bracket
firmly along its entire length for 10-15 seconds.
3. Firmly press the bracket to the mounting surface along its entire length for 10-15 seconds.
4. Remove the backing from the VHB tap already supplied in the bracket and secure the sensor.
 Make sure the sensor is securely in the bracket, with the bracket arms sitting in the groove in the
sensor body.
Push bracket firmly for 15-20 seconds: Remove backing from VHB tape:
Clip in sensor and orient correctly: Example: sensor at 45 ° toward door:
Mounting PIR sensor on Using VHB Tape
Masonry/Cement
Masonry or other rough or crumbly surfaces must be avoided. If you can’t find an appropriate alternative
surface, contact your Help desk for suggestions on how to proceed.