User`s manual

Intel-GE Care Innovations™ QuietCare® System
Hardware Maintenance Guide
Document: DHF-3756 Page 47 of 60
Revision: 1.0 Effective: January 29, 2012
Positioning:OutsideBathroom
 Position the sensor to detect motion immediately as the senior leaves the bathroom.
CAUTION: Make sure the sensor cannot see inside the bathroom or out of the residence (when the
resident’s front door is open).
 Place the sensor on the exterior wall of the door and angled at 45 degrees toward or across the
doorway.
 In narrow hallways or bedrooms, you may install the senor above the doorway as well, with the
sensor rotated out no more than 45 degrees.
 Motion detected by this sensor during the senior’s AM Bedroom Exit window will signal that the client
is awake. So if possible, position the sensor such that it cannot see the bed or area where senior
sleeps at night.
 After determining the appropriate placement, mount the bracket using screws included.
 When installing above the door, place sensor several inches above the doorway, about a quarter of
the door width away from the door knob side of the doorway, as shown in the image below. Install
sensor with antenna pointed toward door-knob side of doorway and rotate to point the sensor
downwards.
Positioning:NearDoor
This sensor should be installed for all installations. QuietCare can monitor up to two doorways. If there are two
or more entrance doorways to the residence, install each sensor and assign a Near Door role to each sensor.
DO NOT install a Near Door sensor on a doorway that leads outside of the facility.
 The Near Door sensor should only be able to detect motion in the immediate area of the doorway, and
should not be able to detect motion outside of the residence.
 Install sensor above the entrance doorway of the resident room
a. When installing this sensor, only the standard bracket should be used, without a wedge.
 When installing above the door, place sensor several inches above the doorway, about a quarter of
the door width away from the door knob side of the doorway, as shown in the images below. Install
sensor with antenna pointed toward door-knob side of doorway.
 Rotate the sensor in towards the wall such that it can only detect motion no more than 1 – 2 feet into
the residence. Be sure it cannot detect any motion outside of the residence.
 Walk through the doorway several times to be sure it can detect your movement. Watch for the Green
LED to flash on the sensor, and observe where you were when you were detected. If it detected you
too far into the residence, rotate sensor in towards wall, and try test again.
Positioning:For
NightMotion
The optional Night Motion feature is designed for those residents who present a high fall risk or who need
assistance with ambulation.