User`s manual
Intel-GE Care Innovations™ QuietCare® System
Hardware Maintenance Guide
Page 38 of 60 Document: DHF-3756
Revision: 1.0 Effective: January 29, 2012
Do not place on exterior walls whenever possible, as they may tend to get cold, and distort room
temperature data.
Connecting the Base Station
After positioning the antenna and base station, connect them and connect the base to the phone line. If
necessary, integrate the base station with a Personal Emergency Response (PERS) unit or an answering
machine.
Units to Connect Connection Steps
QuietCare only 1. Plug the line on the antenna into the base
station at the opening marked ANTENNA.
2. Insert the phone line from the wall jack into the
opening marked LINE on the base station.
3. Insert the line from the phone into the opening
marked PHONE on the base station.
4. To confirm connectivity, refer to Confirming Base
Station Connectivity section.
QuietCare with a PERS (Personal Emergency
Response System)
1. Plug the line on the antenna into the base
station at the opening marked ANTENNA.
2. Because the PERS unit must have phone
priority, insert the line from the wall jack into
the PERS unit.
3. Insert the line from the PERS unit into LINE on
the base station.
4. Insert the line from the phone into PHONE on
the base station.
5. To confirm connectivity, refer to Confirming
Base Station Connectivity section.
QuietCare with an answering machine or Caller
ID
1. Plug the line on the antenna into the base
station at the opening marked ANTENNA.
2. Insert the line from the wall jack into LINE on
the base station.
3. Insert the line from the answering machine into
PHONE on base station.
4. Insert the line from the phone into the
answering machine.
5. To confirm connectivity, refer to Confirming
Base Station Connectivity section.
QuietCare, PERS, and answering machine/Caller
ID
1. Plug the line on the antenna into the base
station at the opening marked ANTENNA.
2. Insert the line from the wall jack into the PERS
unit.
3. Insert the line from the PERS unit into LINE on