User`s manual

Intel-GE Care Innovations™ QuietCare® System
Hardware Maintenance Guide
Document: DHF-3756 Page 27 of 60
Revision: 1.0 Effective: January 29, 2012
 Rotate the sensor in towards the wall such that it can only detect motion no more than 1 – 2 feet into
the residence. Be sure it cannot detect any motion outside of the residence.
 Walk through the doorway several times to be sure it can detect your movement. Watch for the Green
LED to flash on the sensor, and observe where you were when you were detected. If it detected you
too far into the residence, rotate sensor in towards wall, and try test again.
Positioning:DoorContact

This sensor should be installed for all installations where the Wander feature is intended to be used. It should
be installed on the primary entrance for the resident. If two doors, place on the door most often used most
frequently by the resident. After installing, ensure LED flashes after opening & shutting the door.
Positioning:ForNightMotion
The optional Night Motion feature is designed for those residents who present a high fall risk or who need
assistance with ambulation.
For the Night Motion feature, sensors are placed in the residence in such a manner as to detect the resident
while out of bed and moving around the apartment at night, while not detecting movement in the bed or
sleeping chair.
To install the Night Motion feature:
- The Bedroom sensor should be installed such that it could not detect motion of the resident on the
bed, but can detect motion in the area just off the bed.
o As a general rule, place sensor about 8 inches – 12 inches off side of bed, to avoid detecting
motion of resident in bed, which can lead to false-positive Night Motion alerts.
o Since the sensors cannot detect motion above the top lens of the sensor, installing the sensor
horizontally may be best.
- If the resident could exit the bed on two sides, an extra sensor may need to be added to detect that
side of the bed. Use another sensor with the bedroom role as the second sensor if possible.
The sensor positioning guidelines described in this document also apply to Night Motion installations, with the
exception of detecting motion on the bed.
In some instances, it may not be possible to install sensors for Night Motion without breaking one of these
installation rules. If this will be the case, check with your installations manager before you proceed.