User`s manual

Intel-GE Care Innovations™ QuietCare® System
Hardware Maintenance Guide
Page 26 of 60 Document: DHF-3756
Revision: 1.0 Effective: January 29, 2012
 Motion detected by this sensor during the senior’s AM Bedroom Exit window will signal that the client
is awake. So if possible, position the sensor such that it cannot see the bed, or area where senior
sleeps at night.
 Mount the wedge bracket if installing sensor vertically, using screws included. Attach the standard
bracket to the wedge bracket.
 When installing above the door, place sensor several inches above the doorway, about a quarter of
the door width away from the door knob side of the doorway, as shown in the image below. Install
sensor with antenna pointed toward door-knob side of doorway.
 In this installation, only the standard bracket should be used, without a wedge.
Rotate the sensor downwards as shown in the images below:
Positioning:K:NearDoor
This sensor should be installed for all installations. QuietCare can monitor up to two doorways. If there are two
or more entrance doorways to the residence, install each sensor and assign a Near Door role to each sensor.
DO NOT install a Near Door sensor on a doorway that leads outside of the facility.
 The Near Door sensor should only be able to detect motion in the immediate area of the doorway, and
should not be able to detect motion outside of the residence.
 Install sensor above the entrance doorway of the resident room
a. When installing this sensor, only the standard bracket should be used, without a wedge.
 When installing above the door, place sensor several inches above the doorway, about a quarter of
the door width away from the door knob side of the doorway, as shown in the images below. Install
sensor with antenna pointed toward door-knob side of doorway.