Operation Manual

4.3 AUDIO SOURCES AND PRIORITIES
If two connected audio sources try to play simultaneously, your
scala rider automatically determines which audio source to play
through the speakers based on the priority of the connected devices.
Higher Priority
1. Mobile Phone audio or GPS instructions*
2. Intercom / Click-to-Link
3. A2DP (Stereo Bluetooth) audio
4. FM Radio (Built-in)
5. AUX (for corded connection i.e. Music Players)
* GPS instructions from Smartphone GPS Apps
are prioritized like A2DP audio

Lower Priority
• Incoming mobile phone calls interrupt ongoing intercom calls
• Incoming intercom calls will interrupt ongoing A2DP music
• Intercom and Click-to-Link calls have the same priority. So
Click-to-Link calls will not interrupt any Intercom call in progress,
and vice-versa.
A2DP audio priority can be congured to be higher than Intercom audio
priority (see section 3).
4.4 VOICE CONNECT VOX SETTINGS
The scala rider oers VOX technology for safe and hands-free
operation of some key functions.
VOX Activation Speak any word loudly into the microphone
Answer a call Speak any word loudly into the microphone
Reject a call Remain silent for about 15 seconds
VOX Sensitivity
(Default:
Medium)
See section 3 to adjust settings.
High: Use this setting if it is dicult to activate VOX
Low: Use this setting if it is too easy to activate VOX
Enable/Disable
VOX (For
Intercom/Voice
Command only)
In Standby, press and simultaneously for 2 seconds
• Enable: Blue ash for 2 seconds
• Disable: Red ash for 2 seconds
5. INTERCOM
The scala rider Q1 allows Rider-to-Passenger full duplex intercom
communication.
To chat with another scala rider via Intercom, pair your scala rider Q1
to the second device. Pairing is a one-time process. Once paired, the
two units will automatically recognize each other whenever in range.
5.1 INTERCOM COMPATIBILITY
Your scala rider Q1 is compatible with most scala rider models
for intercom calls. In addition, it is also compatible with the
Schuberth SRC-System™. Intercom range with other models is
limited to the distance of the device with the shorter range.
For details on how to pair and use your Q1 with other scala rider
models, please visit www.cardosystems.com/Q1compatibility.
5.2 PAIRING THE INTERCOM CHANNEL
Pairing will replace any existing paired device with the new device.
If you have purchased the Q1 TeamSet , the retail package contains two
pre-paired units. If for any reason you have to pair them again, OR if you
wish to pair another unit, proceed as follows:
1. Check both scala riders are in Standby.
2. On the Q1, press and hold the
v
button for 5 seconds. The
LED will begin ashing RED and the Q1 will now be in intercom
pairing mode.
3. Enter intercom pairing mode on the second unit by following
the device’s instructions. Both units will now be in intercom
pairing mode.
4. After a few seconds, the Q1 will show a solid RED light for
2 seconds, indicating that it is paired and ready to use.
5. If Pairing is not completed within two minutes, the units will
return to Standby mode.
scala rider
®
Q1 / Q1 TeamSet™ | 7