Operation Manual

6.3 LISTENING TO MUSIC VIA A2DP
The scala rider can also receive audio via an MP3 cable from
non-Bluetooth MP3 Players or audio sources (see section 6.5)
Available only on AVRCP compatible Bluetooth audio sources
Play In Standby, tap
W
Pause/Stop Press
W
for 2 seconds
Next Track With music ON, tap
W
Previous Track* With music ON, double tap
W
Music Scan
With music ON, press
+
(scans up) or
-
(scans down)
for 5 sec. The rst few seconds of each track will play.
Stop Scan
To stop the scan on the current track, say any word
loudly into the microphone or tap
W
*With some phones you may need to repeat this action
SWITCHING BETWEEN A2DP AUDIO SOURCES
1. Stop the music playback from the current device.
2. Start music playback from the other device.
6.4 MUSIC SHARING
Music Sharing allows rider and passenger to listen to the
same music within a range of 33 ft / 10m.
Music Sharing works only with A2DP (Bluetooth stereo)
enabled audio sources. In order to share your music with your riding
partner, your scala rider unit [SENDER] needs to be paired to the
other unit [RECEIVER] and the RECEIVER must be in Standby mode.
[SENDER] Start/Stop sharing
your music:
During A2DP music playback, press
+
or
-
for 2 seconds
[RECEIVER] Stop music sharing:
Press
+
or
-
for 2 seconds
Phone/Intercom calls and GPS audio navigation will override music
playback.
Music Sharing does not transmit voice audio and cannot be used as an
Intercom call.
6.5 CABLECONNECTED MP3 PLAYERS
The USB Port can be used to connect a non-Bluetooth audio source
using an MP3 cable.
Micro USB / AUX •
1. Check that the scala rider is in Standby.
2. Connect the cable to the Music Player’s jack and insert the other
end into the USB Port.
To listen to music from a cable-connected device, operate the
Music Player using its buttons as usual (FF/REW/PLAY/PAUSE).
10 | scala rider
®
Q1 / Q1 TeamSet™