Systems, Inc. Bluetooth Headset User Manual

7
English
SCALA RIDER
®
Q2
™
MultiSet |
3. Search for Bluetooth headsets on your GPS device by following
the device’s instructions. Please consult your GPS device’s User
Manual for more information.
4. If your GPS device prompts for a PIN or Passkey enter 0000 (four zeros).
5. Your GPS device will conrm that pairing has succeeded. The
headset will begin ashing slowly in Blue.
6. If you wish to use a Bluetooth mobile phone to make and
receive calls through the headset, you must now pair your
mobile phone to your GPS device by following your GPS
and/or mobile phone’s instructions.
NOTE: If the Pairing process is not completed within two
minutes the headset will return to Standby mode.
ATTACHING THE CLAMP ON THE HELMET
The Helmet Clamp must be attached to the left side of the helmet.
Once attached, the headset unit can be mounted or released from
the Helmet Clamp at any time. There are two methods that can be
used in order to attach the Clamp onto the helmet:
Standard Method: Recommended for most helmet types.
Glue Plate Method: Recommended for helmets
to which the standard method cannot be applied,
using the Glue Plate included in the box.
Standard Method
1. Use the enclosed Allen Wrench to loosen
the two screws on the Back Plate.
2. Slide the Back Plate between the internal
padding and the external shell of the
helmet.
3. Adjust the Clamp’s location so that the
microphone is located opposite the center of your mouth,
and then tighten the screws.
You may need to reposition
the Clamp repeatedly until
you identify the best spot. The
microphone must be positioned
vertically and not horizontally.
Glue Plate Method
You have the option to glue the Helmet Clamp onto your helmet,
when the above standard method cannot be used, or in case you
prefer to secure the Helmet Clamp with adhesive glue. This option
has been successfully used for a range of high end helmets.
NOTE: While we have no reason to believe that the gluing op-
tion might negatively aect any helmet, Cardo does not
assume any responsibility to that aect, irrespective of
its nature and circumstances. The Glue Plate is oered
as a free option that you may choose to use at your own
risk and subject to renouncement of any future claims.
Caution: This process can be done only once!
1. Use the enclosed Allen Wrench to remove both Allen
screws and release the Helmet Clamp’s back plate.
2. Determine the location on the helmet where the
Helmet Clamp must be attached.
3. Adjust the Helmet Clamp’s location on
the Helmet so that the microphone
is located opposite the center of your
mouth. You may need to reposition
the Clamp repeatedly until you identify
the best spot. The microphone must be
positioned vertically and not horizontally (Be sure to clean the selected
area prior to the gluing process as described in # 4 below).
CORRECT INCORRECT
Allen
Wrench
Back
Plate
CORRECT INCORRECT