Operation Manual

NOTES:
• Not all Bluetooth mobile phones can broadcast Bluetooth Stereo
music (A2DP), even if the phone has an MP3 player function.
Consult your mobile phone’s User Manual for more information.
• Not all Bluetooth GPS devices allow connection to Bluetooth audio
devices. Consult your GPS User Manual for more information.
• After pairing, you may need to tap
to connect.
6.2 MAKING AND RECEIVING PHONE CALLS
Answer a call
Tap
or speak any word loudly to answer
by VOX
Reject a call
Remain silent for 15 seconds, or press
for
2 seconds
End a call
Tap
Voice Dial* (if supported
by mobile phone)
Tap
and follow the prompt from the
mobile
Redial*
Double-tap
Hot Dial*
†
Double-tap
or tap and
simultaneously
Set default mobile
‡
While on a phone call, press
for 5 seconds
Change default mobile
In Standby, press
and for 5 seconds
INTERCOM CONFERENCE MODE
Add/Remove Channel “A”
to/from a call
Tap
while on a phone call
Add/Remove Channel “B”
to/from a call
Tap
while on a phone call
* This feature is not available during intercom or mobile calls
† Before using Hot-Dial, congure your Hot-Dial number via the Cardo Community.
‡ If you have 2 mobile phones paired directly to your scala rider G9x, you will need
to set one of them to use as default for outgoing calls.
6.3 LISTENING TO MUSIC VIA A2DP
Available only on AVRCP compatible Bluetooth audio sources
The scala rider G9x can also receive audio via an MP3
cable from non-Bluetooth MP3 Players or audio
sources as described in section 6.5.
Play
In standby, press
for 2 seconds or use Voice Command
Pause/Stop
Press
for 2 seconds or use Voice Command
Next Track
With music ON, press
for 2 seconds or use Voice Command
Previous
Track*
With music ON, press
for 2 seconds or use Voice Command
Music Scan
With music ON, press
(scans up) or (scans down) for 5 sec.
The rst few seconds of each audio track will be played.
Stop Scan
To stop the scan on the current track, say any word loudly into
the microphone or press
for 2 seconds
*With some phones you may need to repeat this action
SWITCHING BETWEEN A2DP AUDIO SOURCES
If a Music Player is paired, the scala rider G9x will use it as the
default A2DP audio source.
1. Stop the music playback from the current device.
2. Start music playback from the other device.
6.4 MUSIC SHARING
Music-sharing allows rider and passenger to listen to the
same music within a range of 33 ft / 10m.
Music sharing works only with A2DP (Bluetooth stereo)
enabled audio sources. In order to share your music with your
riding partner, your scala rider [SENDER] needs to be paired to the
other unit [RECEIVER] on CHANNEL A and the RECEIVER must be in
Standby mode.
English
scala rider
®
G9x / G9x PowerSet | 13