Operation Manual
s
c
a
l
a
r
i
d
e
r
G
9
I
n
t
e
r
c
o
m
O
p
t
i
o
n
s
C
l
i
c
k
-
t
o
-
L
i
n
k
S
p
o
n
t
a
n
e
o
u
s
I
n
t
e
r
c
o
m
4
W
a
y
I
n
t
e
r
c
o
m
C
o
n
f
e
r
e
n
c
i
n
g
“
1
+
8
”
I
n
t
e
r
c
o
m
T
o
g
g
l
i
n
g
Intercom communication is possible using one of the three
Intercom modes:
Section
5.1
“1+8” Intercom Toggling
Mode
(between scala rider
G9 / G9x and cardo
SHO-1 only)
2-way Intercom conversations
within a group of up to eight other
“1+8” Buddies
Section
5.2
Intercom via Channels
“A” and “B” (with any
Cardo intercom model)
Intercom Conferencing (2-way,
3-way and 4-way) using Channels
“A” and “B”
Section
5.3
Click-to-Link
(with compatible
models)
1-on-1 spontaneous intercom
conversations with random riders
near you who are not already
paired to your scala rider G9
5.1 “1+8” INTERCOM TOGGLING MODE
Pair with up to 8 other devices (“1+8” Buddies) and connect
with them one at a time by saying their name.
5.1a CONFIGURING YOUR BUDDY NAME
Before using “1+8” Intercom, you should assign your device a
Buddy Name, so that other “1+8” participants can call you by this
name.
If you change your Buddy Name, you must pair again with your
“1+8” Buddies for their device to receive your new Buddy Name.
Visit the Cardo Community to congue your Buddy Name (see
Section 3). Until you congure a Buddy Name, your unit will be
known by its generic “1+8” Buddy name, “scala rider G9”.
Hear Your
Buddy Name
In Standby, tap u and b simultaneously. You will hear
the Buddy name of your scala rider G9 through the
speakers.
Play Paired
Buddy List
In Standby, press u for 2 seconds
5.1b PAIRING WITH A “1+8” INTERCOM BUDDY
There are three ways to pair with “1+8” intercom buddies:
OPTION 1: Pairing via the Cardo Community®
Easily nd and add your friends to your “1+8” Buddy list via the
Cardo Community at: http://community.cardosystems.com
OPTION 2: Flash-Pairing™ (with other G9 or G9x models)
Use Flash-Pairing to pair within seconds.
1. Remove both units from their Audio Kits and check they
are in Standby (slow single blue ashing).
2. Bump the two units gently against each other and hold them
side by side.
8
| scala rider
®
G9 / G9 PowerSet