Operation Manual
6
scala rider
®
FM
™
2. Slide the Back Plate between the internal padding
and the external shell of the helmet.
3. Adjust the clamp’s location so that the
microphone is located opposite your
mouth and then tighten the screws.
You may need to reposition the Clamp
repeatedly until you identify the best
spot. The microphone must be positioned
vertically and not horizontally.
Glue Plate Method
You have the option to glue the Helmet Clamp
onto your helmet, when the above standard method cannot be
used, or in case you prefer to secure the Helmet Clamp with adhesive
glue. This option has been successfully used for a range of high end
helmets.
NOTE: While we have no reason to believe that the gluing
option might negatively affect any helmet, Cardo
does not assume any responsibility to that affect, ir-
respective of its nature and circumstances. The Glue
Plate is offered as a free option that you may choose
to use at your own risk and subject to renouncement
of any future claims.
Caution: This process can be done only once!
1. Use the enclosed Allen Wrench to remove both Allen screws
and release the Helmet Clamp’s back plate.
2. Determine the location on the helmet where the
Helmet Clamp must be attached.
3. Adjust the Helmet Clamp’s location on the Helmet so that the
microphone is located opposite your mouth. You may need to
reposition the Clamp repeatedly until you
identify the best spot. The microphone must
be positioned vertically and not horizontally
(Be sure to clean the selected area prior to
the gluing process as described in # 4 below).
4. Use the pre-moistened Towelette to clean the helmet
area where you want to install the Glue Plate. Allow to dry
thoroughly.
5. Peel the foil cover from the Glue Plates’ adhesive pad.
6. Place the Glue Plate into position according to #3. Press rmly 15
seconds on all 3 parts of the Glue Plate.
7. The adhesive pad bonds to full strength over the next 24 hours.
Therefore it is recommended to not use the headset during this 24
hour period.
8. Fasten the Clamp to the Glue Plate using the Allen screws that were
previously removed.
POSITIONING THE SPEAKERS
Attach the speakers to the Velcro inside your helmet opposite your ears
(short speaker cord for the left ear [A] and the long speaker cord [B] for
the right ear). You may want to use the sup-
plied Velcro pad.
Using two speakers inside the
helmet may be prohibited in
certain jurisdictions. If this is the
Speaker A
Speaker B
6
scala rider
®
FM
™