Operation Manual

4
scala rider
®
FM
™
Wall Charger
Allen Wrench
Velcro Pads
MP3 Cable
MP3 Cable Holder
Glue Plate
Pre-moistened Towelette
Carry-Pouch
Microphone Sponges
Flat sponge for full-face helmets and round sponge for other helmet types
User Guide, including Warranty and Registration form
IMPORTANT:
The scala rider FM is a water-resistant device, designed for use under
moderate rain or snow conditions. However, the headset is not
waterproof and should not be used under severe weather conditions.
The cover tongue protecting the Charging Jack should be kept tightly
closed at all times to prevent moisture from entering the device.
BEFORE USING (CHARGING THE
HEADSET)
Make sure that the headset is fully charged for at least four hours
before initial use.
1. Connect the wall charger to the headset’s Charging Jack (located
between the two Volume Buttons).
2. While charging, the Red Light turns on (it may take up to 15
seconds until the Red Light turns on). When charging is complete,
the Red Light will turn o.
SET UP AND CONFIGURATION
SET UP FOR MOBILE PHONE CALLS
If you have a Bluetooth enabled mobile phone and would like
to make and receive phone calls using the scala rider FM, you
must rst pair your headset to the mobile phone.
Pairing is a one time process. Once the headset is paired to a
specific mobile phone during this Setup Procedure, they will
remain paired and automatically recognize each other whenever
they are within range. If the connection between the phone and
headset is lost, tap the CTRL button to reconnect the devices.
TO PAIR THE SCALA RIDER FM TO A BLUETOOTH MOBILE PHONE
1. Turn on your phone and make sure its Bluetooth function is
activated.
2. With the scala rider FM headset turned OFF, press and hold the
CTRL Button until the Red and Blue Lights begin rapidly alternating.
3. Search for Bluetooth devices on your phone by following the
phone’s instructions. Please consult your phone’s User Manual
for more information.
Mobile Phone MP3 Player
GPS
FM Radio