™ English FM ™ communication in motion ™ Gebrauchsanleitung Guide d’Utilisation Guida di Avvio Guia de Usario User Guide scala rider® FM™ 1
scala rider® FM™
Congratulations, and thank you for choosing the scala rider FM Bluetooth Headset for Motorcycle helmets. CONTENTS OF RETAIL BOX Volume Up Headset The scala rider FM headset offers the following uses: Cover tongue & Charging Jack 1. Bluetooth headset for mobile phone communication, supporting Headset *and Handsfree* profiles (10m / 33 ft. range) 2. Transmitting GPS navigation instructions from a Bluetooth enabled GPS device 3. FM Radio – built in FM radio receiver with six preset stations 4.
SET UP AND CONFIGURATION Wall Charger Allen Wrench Velcro Pads MP3 Cable FM Radio MP3 Cable Holder Mobile Phone Glue Plate GPS MP3 Player Pre-moistened Towelette Carry-Pouch Microphone Sponges Flat sponge for full-face helmets and round sponge for other helmet types User Guide, including Warranty and Registration form IMPORTANT: The scala rider FM is a water-resistant device, designed for use under moderate rain or snow conditions.
NOTE: If the Pairing process is not completed within two minutes the headset will return to Standby mode. With some mobile phones, you may need to tap the CTRL button to connect the headset to the phone after pairing is complete. The scala rider FM headset will automatically connect to the last phone connected to the headset.
2. Slide the Back Plate between the internal padding and the external shell of the helmet. 3. Adjust the clamp’s location so that the microphone is located opposite your mouth and then tighten the screws. You may need to reposition the Clamp repeatedly until you identify the best spot. The microphone must be positioned vertically and not horizontally.
Cable Speaker B Speaker B USING THE HEADSET Speaker A ATTACHING AND REMOVING THE HEADSET FROM THE HELMET CLAMP ATTACHING: Slide the headset downwards along the sliding panel until a clicking sound indicates that the headset is locked in place. REMOVING: Your headset can be removed for charging and storage by pressing your finger gently against the tab and sliding the headset up with the other hand. We recommend that you remove the headset from the helmet when not in use. Highest: 1.
Control without having to remove your hands from the handlebars. The default mode of this feature is ON (enabled). Each time you switch off and turn on the headset, the VR feature will be automatically enabled. To disable / enable the VR feature press and hold the Volume Up and Volume Down simultaneously for three seconds. You will hear an ascending / descending tone confirming the change each time you switch this feature ON or OFF respectively.
Turning the FM Radio Off While the radio is turned on, press and hold the Radio Button for three seconds to turn the Radio off. Switching Preset FM Radio Station There are six pre-set Radio stations available on your scala rider FM. While the Radio is on, tap the Radio Button to cycle between saved stations. Searching for a New FM Radio Station While the Radio is on, press and hold the Volume Up or Volume Down Button for three seconds or until you hear the next station on your headset.
6. Connect the MP3 cable to your MP3 player device’s jack and the other side to the helmet Clamp’s jack, inserting the cable through the MP3 cable holder. Make sure that the cable plug clicks into place. 7. Tuck the MP3 cable into the hook of the MP3 cable holder. 8. In order to use your MP3 player, power on the headset to have it on Standby mode, flashing slowly in Insert cable in hook Blue. NOTE: Operate the MP3 Player device by using its buttons (FF/REW/ PLAY/PAUSE).
Industry Canada (IC) Statement You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the IC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
malfunctioning of the Device, and all risks associated with operating it rest solely and entirely with the user of this Device, irrespective of whether the Device is used by the original purchaser or any third party. Cardo hereby notifies you that using this Device may also be in contravention to local, federal, state or national laws or regulations, and that any use of the Device is entirely at your sole risk and responsibility. 1.
