User guide
5. PAIRING AND USING A MOBILE PHONE, GPS
DEVICE OR MP3 PLAYER
To connect your scala rider to a Bluetooth device you must rst pair
them. Once paired, they will automatically recognize each other
whenever they are within range (10m / 33ft).
Your scala rider has two Bluetooth channels for connection to
mobile phones, GPS devices and music players with A2DP.
5.1 PAIRING BLUETOOTH CHANNELS 1 AND 2
1. Make sure Bluetooth is enabled on your phone/GPS/MP3 player.
2. Check the scala rider is in Standby (single BLUE ash every
3 seconds).
3. To pair Bluetooth Channel 1 – press for at least 5 seconds until
the RED and BLUE LEDs begin rapidly alternating.
To pair Bluetooth Channel 2 – press for at least 5 seconds until
the RED and BLUE LEDs begin rapidly alternating.
4. Search for Bluetooth devices on your phone/GPS/MP3 player by
following the device’s instructions.
5. After a few seconds the device will list “scala rider Qz ”. Select it.
6. If prompted for a PIN or Passkey, enter 0000 (four zeros).
7. The device will conrm that pairing has succeeded and the
scala rider will begin ashing slowly in BLUE.
8. If Pairing is not completed within 2 minutes, the scala rider will
return to Standby mode.
scala rider
®
Qz |
7