User guide
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specic operating
instructions for satisfying RF exposure compliance. This transmitter must
not be co-located or operating in conjunction with any other antenna or
transmitter.
Industry Canada (IC) Statement
15.21
You are cautioned that changes or modications not expressly approved
by the part responsible for compliance could void the user’s authority to
operate the equipment.
(b)15.105
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the IC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may
cause undesired operation of the device.
IC RF Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specic operating
instructions for satisfying RF exposure compliance. This transmitter must
not be co-located or operating in conjunction with any other antenna or
transmitter.
European CE Notice
The scala rider G4 Instructor Kit (the “Product”) is in conformity with the fol-
lowing essential requirements of Council Directive 1999/5/EC (referred to as
R&TTE Directive): Articles 3.1a, 3.1.b and 3.2. The Product is manufactured in
accordance with Annex II of the above directive.
Declaration of Conformity (DOC)
The scala rider G4 Instructor Kit is compliant with and adopts the Bluetooth®
Specication 2.1 and has successfully passed all interoperability tests
that are specied in the Bluetooth® specication. However, interoper-
ability between the device and other Bluetooth®-enabled products is not
guaranteed.
WAIVER AND GENERAL RELEASE
By using the scala rider G4 Instructor Kit you will waive substantial legal
rights including the right to sue. Please read the following carefully
before using the device. If you do not accept all terms of this agree-
ment, you should immediately return the product for a full refund. By
using the headset you agree to be bound to this agreement and forfeit
the right to sue.
14
scala rider
®
G4
™
Instructor Kit