User guide

English
* Depending on the type of scala rider G4 Instructor Kit purchased – a set
for one trainee (trainee 1) or for two trainees (trainee 1 & trainee 2).
** This step applies only to the scala rider G4 Instructor Kit package for 2
trainees, referred to in the manual as trainee 1 and trainee 2.
NOTE: The scala rider G4 Instructor Kit, contains two or three
factory paired G4 headsets, depending on the type of Kit purchased.
If you did not change the original pairing settings, you can skip the
steps below and proceed with how to use the Intercom:
8.2 PAIRING THE BLUETOOTH SPEAKERPHONE TO THE
INSTRUCTOR’S HEADSET
1. Starting with the speakerphone turned o, press and hold
the speakerphone’s Control Button for at least nine seconds
until the Red and Blue Lights begin rapidly alternating.
2. With the Instructor’s headset turned ON, press and hold the
CHANNEL A Button for at least six seconds until the Red
light begins ashing rapidly.
3. Within a few seconds, the Instructor’s headset will show
a solid red light for two seconds, indicating that the
two devices are now paired and connected. This will be
followed by the Speakerphone’s conrmation tone.
NOTE: If the Pairing process is not completed within two minutes the
headset will return to Standby mode and the speakerphone will turn
o.
8.3 PAIRING THE INSTRUCTOR TO TRAINEE 1
1. If either headset is turned OFF, turn it ON by pressing and
holding the Control Button until the Blue Light ashes three
times.
2. Make sure that both headsets are now ashing slowly in
Blue.
3. On the Instructor’s headset, press and hold the CHANNEL B
Button for at least six seconds until the headset’s BLUE Light
begins ashing rapidly, indicating it is in Intercom Pairing
mode.
4. On the trainee 1 headset, press and hold the CHANNEL A
Button for at least six seconds until the headset’s RED Light
begins ashing rapidly, indicating it is in Intercom Pairing
mode.
5. Within a few seconds, both headsets will show a constant
light for two seconds, indicating that the two headsets are
now paired, connected and ready for use.
NOTE: If the Pairing process is not completed within two minutes the
headsets will return to Standby mode.
8.4 PAIRING TRAINEE 1 TO TRAINEE 2 HEADSET*
1. If either headset is turned OFF, turn it ON by pressing and
holding the Control Button until the Blue Light ashes three
times.
2. Make sure that both headsets are now ashing slowly in Blue.
3. On the Trainee 1 headset, press and hold the CHANNEL B
Button for at least six seconds until the headset’s BLUE Light
begins ashing rapidly, indicating it is in Intercom Pairing
mode.
4. On the Trainee 2 headset, press and hold the CHANNEL A
Button for at least six seconds until the headset’s RED Light
begins ashing rapidly, indicating it is in Intercom Pairing
mode.
5. Within a few seconds, both headsets will show a constant
light for two seconds, indicating that the two headsets are
now paired, connected and ready for use.
NOTE: If the Pairing process is not completed within two minutes the
headsets will return to Standby mode.
* Refers to the scala rider G4 Instructor Kit package for 2 trainees
11
scala rider
®
G4
™
Instructor Kit