User guide

2. CONTENTS OF THE RETAIL BOX
Helmet clamp (subject to the version purchased: Boom-Mounted or Cord-
Mounted Microphone)
Two speakers
Noise
canceling
microphone
Flexible Boom
scala rider G4 headset
Flip-up
antenna
Channel A
Button
• Connect to
Rider A
• MP3 Button
Channel B Button
• Connect to Rider B
• FM Radio Button
Mobile
Phone
Button
Volume Up /
Forward
Button
Volume
Down /
Rewind
Button
Charging Jack
& Firmware
download port
Wall charger plug
USB adapter cable
Allen wrench
Velcro pads
MP3 cable
Glue plate
Pre-moistened Towlette
Carry pouch
Microphone sponges
Flat sponge for full-face helmets and round sponge for other helmet types
User Guide, Warranty and Registration form
The scala rider G4 is also available in a cord-mounted microphone
version to better t certain full-faced helmets with tight chin sections
IMPORTANT:
Your scala rider G4 is a water-resistant device, designed for use under
moderate rain or snow conditions. However, the headset is not rated
waterproof and should not be used under severe weather conditions. The
cover lid protecting the Charging Jack should be kept tightly closed at all
times to prevent moisture from entering the device.
3. CHARGING THE HEADSET
Make sure that your headset is fully charged for at least four hours
before initial use. Open the silicone cover protecting the Charging
jack and Firmware download port.
Insert the USB cable to the wall charger and insert
the other end of the cable to the headset’s Charging
Jack. While charging, the Red Light turns on. When
charging is complete, the Red Light will turn o.
Sliding Panel
Silicone cover
MP3 Jack
(back of clamp)
LED
4
scala rider
®
G4
™