User guide

English
Making 4-Way Intercom calls
Once you have successfully paired the four headsets as described
above, and all units are in standby mode, proceed as follows to start a
4-way Conference Intercom call:
a. Passenger 2 should press Button “B” to initiate a call with
Passenger 4. Wait until audio is heard on both headsets and
proceed to the next step.
b. Driver 1 should press Button “A” to initiate a call with
Passenger 2.
c. Driver 3 should press Button “A” to initiate a call with
Passenger 4.
Now the 4-way intercom conference mode is established.
NOTE: If one of the headsets should disconnect or drop o from the
4-way call and fails to reconnect, repeat the three steps above in
that precise order.
9.11 USING THE G4 FOR INTERCOM WITH OTHER
SCALA RIDER HEADSETS
INTERCOM
CHANNEL
PAIRING / CONNECTION
BUTTON
PAIRING MODE LED
INDICATORS
CHANNEL “A” CHANNEL “A” BUTTON Rapid RED ashing
CHANNEL “B” CHANNEL “B” BUTTON Rapid BLUE ashing
9.11a. TWO-WAY INTERCOM with scala rider Q2
To use your scala rider G4 with a scala rider Q2 headset, we recom-
mend that you also refer to your Q2 headset manual.
1. If either headset is turned OFF, turn it ON by pressing and holding
either the Mobile Button for the G4 unit or the CTRL Button for the
Q2 unit until the Blue Lights ash three times.
2. Make sure that both headsets are now ashing slowly in Blue.
3. On the G4, select an available CHANNEL to pair the headset (CHAN-
NEL “A” or CHANNEL “B”).
NOTE: Selecting a CHANNEL that is already in use will replace the paired
headset on that CHANNEL with the newly paired headset.
4. On the scala rider G4 headset, press and hold the assigned
CHANNEL BUTTON (“A” or “B”) for at least six seconds until the
headset’s BLUE or RED Light begins ashing rapidly, indicating it is
in Intercom Pairing mode. (See Intercom Channel Table for Pairing
Light indication for each CHANNEL).
5. On the Q2 headset, simultaneously press and hold the CTRL and
MC Buttons until the headset’s RED Light begins ashing rapidly, in-
dicating it is in Intercom Pairing mode (see scala rider Q2 manual).
6. Within a few seconds, both headsets will show a solid light for two
seconds, indicating that the two headsets are now paired, con-
nected and ready for use.
NOTE: If the Pairing process is not completed within two minutes the
headset will return to Standby mode.
9.11b. TWO-WAY INTERCOM with earlier scala rider models
To use your scala rider G4 with any earlier models of the scala rider,
such as the “Solo”, the “FM”, or a “TeamSet” Driver unit make sure you
have the manual of the other scala rider headset available
1. While the G4 headset is turned OFF, turn it ON by pressing and holding
the Mobile Button until the Blue Light ashes three times.
2. Turn the other scala rider headset ON by pressing and holding its
CTRL Button until the Red/Blue lights begin rapidly alternating.
3. For the G4 headset, select an available CHANNEL to pair the head-
set (CHANNEL “A” or CHANNEL “B”).
NOTE: Selecting a CHANNEL that is already in use will replace the paired
headset on that CHANNEL with the newly paired headset.
19
scala rider
®
G4
™