User guide

In this conguration the two passengers (numbered 2 and 4) are each

using two Bluetooth connections:

Passenger 2 is paired to Driver 1 and to Passenger 4

Passenger 4 is paired to Driver 3 and to Passenger 2

IMPORTANT: Since both Passengers each use two Bluetooth connections

during the conference mode, they will both be disconnected from

their mobile phones until the conference mode is terminated.

Upon termination, both Passengers will automatically re-connect

to their mobile phones. Both Drivers 1 and 3 remain connected to

their mobile phones or GPS devices during the 4-way intercom call

PAIRING FOUR SCALA RIDER G4 HEADSETS

INTERCOM

CHANNEL

PAIRING / CONNECTION

BUTTON

PAIRING MODE LED

INDICATORS

CHANNEL “A” CHANNEL “A” BUTTON Rapid RED ashing

CHANNEL “B” CHANNEL “B” BUTTON Rapid BLUE ashing

To converse in the 4-Way intercom conference mode, the four

headsets must be paired as shown in the biker illustration above. All

four units should initially be turned o.

Step One: Pair Driver 1 to Passenger 2 via Channel “A” as follows

a. Turn both headsets ON by pressing and holding the Mobile

Buttons until the Blue Light ashes three times.

b. Both headsets should now be ashing slowly in Blue.

c. Press and hold CHANNEL (“A”) BUTTON on both headsets

for at least six seconds until the headset’s BLUE or RED Light

begins ashing rapidly, indicating that they have entered

the Intercom Pairing mode. (See Intercom Channel Table for

Pairing Light indication for each CHANNEL)

d. Release the buttons and wait until both headsets display a

solid light for two seconds, indicating that the two headsets

are now paired for Intercom connections. (This may take up to

two minutes)

Step Two: Pair Driver 3 to Passenger 4 via Channel “A”

Repeat the above pairing procedure between Driver 3 and Passenger 4

Step Three: Pair Passenger 2 to Passenger 4 via Channel “B”

Repeat the above pairing procedure between Passenger 2 and Pas-

senger 4 using the Channel “B” button. (instead of Channel “A” button

as described in bullet c above).

Your 4-Way Conference Intercom Pairing is now complete and ready

to use.

NOTE: If the Pairing process is not completed within two minutes the

headsets will return to Standby mode.

scala rider

™