User guide

English
9.10b. THREE-WAY INTERCOM
The scala rider G4 oers three-way intercom conference
connectivity as follows:
First G4 unit
Rider “A”
Third G4 unit
Rider “C”
Second G4 unit
Rider “B”
In this conguration Rider “B” is paired to Rider “A” and to Rider “C”.
IMPORTANT: Since Rider “B” uses two Bluetooth connections during the
conference mode, Rider “B” will be disconnected from the mobile phone
or GPS device until the conference mode is terminated. Upon termination,
Rider “B” will automatically re-connect to his mobile phone or GPS. Rider
“A” and “C” remain connected to their mobile phones or GPS devices during
the 3-way intercom call.
Set-up and conguration three-way intercom connectivity
INTERCOM
CHANNEL
PAIRING / CONNEC-
TION BUTTON
PAIRING MODE LED
INDICATORS
CHANNEL “A” CHANNEL “A” BUTTON Rapid RED ashing
CHANNEL “B” CHANNEL “B” BUTTON Rapid BLUE ashing
PAIRING OPTIONS BETWEEN THREE PARTICIPANTS (between
scala rider G4 models only)
Pairing three scala rider G4 headsets is achieved by simply repeat-
ing the procedure in the above section 9.10a with a third paired G4
headset (in a dierent CHANNEL).
Example:
For pairing your G4 with another two G4 headsets:
1. Pair your G4 with the second G4 as described in section 9.10a
(Using CHANNEL “A”).
2. Pair your G4 with the third G4 as described in section 9.10a
(Using CHANNEL “B”)
Initiate Intercom calls
There are two ways to start an Intercom call with your paired headsets
while the headset is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an
Intercom call will be established
with both paired headsets, CHAN-
NEL “A” and CHANNEL “B” (if both
are available).
CHANNEL BUTTON CONNECT:
Single tap the CHANNEL “A” But-
ton to add or remove the CHANNEL
“A” headset from an Intercom call.
Single tap the CHANNEL “B” But-
ton to add or remove the CHANNEL
“B” headset from an intercom call.
9.10c. FOUR-WAY INTERCOM
When connected to three other scala rider G4 units, your headset
can also participate in a 4-way Conference Intercom Call (full duplex)
as explained below.
Please note that the 4-way conference operates in a linear way, whereby
the two passengers serve as the connecting links for the entire group.
Therefore, if one of the Passengers disconnects, the 4-way conference
mode will be interrupted until that passenger is reconnected.
4-Way Intercom between up to two couples on two motorcycles
two drivers (1 and 3) and two passengers (2 and 4)
Use Channel “B”
Use Channel “A”
17
scala rider
®
G4
™