User guide

c. Automatic Reconnection of the Intercom
If the G4 and another paired headset go out of range and discon-
nect from each other, the G4 will immediately try to reconnect to the
other headset.
You can manually reconnect the intercom call while the headset is in
Standby mode by pressing the CHANNEL “A” or the CHANNEL “B” But-
ton to connect to the respective lost connection.
d. Conference Mode Limitations
Whenever you enter the Intercom Conference mode among three
or even four participants (including yourself), the participants who
maintain simultaneously two active connections will not be able to
receive mobile phone calls or GPS messages as long as the confer-
ence call is in progress (see details in sections 9.10 b and 9.10 c)
9.9 TROUBLESHOOTING THE INTERCOM
First, make sure your microphone is located properly in front of the
center of your mouth.
The scala riderG4 is designed for use in loud environments.
Therefore, you should test the Intercom functionality only in a noisy
environment, such as next to an idling motorcycle and not indoors.
Please also verify that the headsets were paired together properly by
following the instructions in the relevant Setup sections.
9.10 USING THE G4 FOR INTERCOM WITH OTHER G4 HEADSETS
INTERCOM
CHANNEL
PAIRING / CONNECTION
BUTTON
PAIRING MODE LED
INDICATORS
CHANNEL “A” CHANNEL “A” BUTTON Rapid RED ashing
CHANNEL “B” CHANNEL “B” BUTTON Rapid BLUE ashing
9.10a. TWO-WAY INTERCOM
PAIRING OPTIONS BETWEEN TWO PARTICIPANTS
Using two scala rider G4 headsets
1. If either headset is turned OFF, turn it ON by pressing and holding
the Mobile Button until the Blue Light ashes three times.
2. Make sure that both headsets are now ashing slowly in Blue.
3. Choose an available CHANNEL you wish to use to pair the headset
(CHANNEL “A” or CHANNEL “B”).
NOTE: Selecting a CHANNEL that is already in use will override the paired
headset on that CHANNEL with the newly paired headset.
4. On the G4 headset, press and hold the chosen CHANNEL BUTTON
(“A” or “B”) for at least six seconds until the headset’s BLUE or RED
Light begins ashing rapidly, indicating it is in Intercom Pairing
mode. (See Intercom Channel Table for Pairing LED indication for
each CHANNEL)
5. Repeat Step 3-4 for the second scala rider G4 headset.
6. Within a few seconds, both headsets will show a solid light for two
seconds, indicating that the two headsets are now paired, con-
nected and ready for use.
NOTE: If the Pairing process is not completed within two minutes the
headset will return to Standby mode.
Initiate Intercom calls
There are two ways to start an Intercom call with your paired headset
while the headset is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an Intercom
call will be established with the other
paired headset.
The Intercom call will stay on until all
participants remain silent for 30 seconds.
CHANNEL BUTTON
CONNECT:
Tap the chosen CHANNEL
Button once to add or
remove the other headset
from an Intercom call.
16
scala rider
®
G4
™