User guide

English
9.4 INITIATE INTERCOM CALLS
Now that you have completed the pairing process, you can start using the
intercom. If you haven’t done so yet, please refer to the table above and
complete your preferred pairing conguration before you proceed with
this section.
There are two ways to start an Intercom call with headsets that are paired
to your scala rider G4 (make sure you are in Standby mode):
VOICE CONNECT:
Preferred for relatively brief conversa-
tions as it takes the channel into standby
mode after 30 seconds of silence
Start talking loudly
Once you start talking loudly, an Inter-
com call will be established with both
paired headsets, CHANNEL “A” and
CHANNEL “B” (if both are available).
The Intercom call will stay on until
all participants remain silent for 30
seconds. (applicable for 2-way
communication)
CHANNEL BUTTON CONNECT:
Preferred for extended conversa-
tions as it leaves the channel open
and active
Single tap the CHANNEL “A”
Button to add or remove the
CHANNEL “A” headset from an
Intercom call.
Single tap the CHANNEL “B”
Button to add or remove the
CHANNEL “B” headset from an
intercom call.
NOTE: While the Intercom is on, the Redial and Voice Dial functions will be
disabled.
9.5 RECEIVING INTERCOM CALLS
Once another paired headset tries calling you via intercom, the call
will begin almost instantly.
NOTE: The headsets preset priority modes have been set in a way to avoid
incoming intercom calls from interrupting mobile phone calls
and GPS instructions in progress. In such case the intercom caller
will hear a busy signal and you will hear two beeps, indicating
that an intercom caller is trying to page you. (see section 4.3 for
details on audio priorities of paired devices).
9.6 ENABLE/DISABLE VOICE CONNECT FEATURE VOX
The G4 oers VOX technology for safe and hands-free operation of
some key functions.
For incoming calls, just pronounce loudly any word (e.g. “hello”). To
reject an incoming call, you need only to remain silent for about 15
seconds. To reject an intercom call remain silent for 30 seconds.
While on standby press and hold the Volume Up and Volume Down
Buttons simultaneously for three seconds until you hear a beep. The
default status is Voice Connect enabled.
NOTE: The Enable/Disable Voice Connect feature aects only the Intercom
functionality.
9.7 RESET PAIRING RESTORING THE ORIGINAL DEFAULT
CONFIGURATION
This section is only relevant once you have completed a pairing process
You can delete all of your paired devices at any time as follows:
1. With the scala rider G4 headset turned ON, press and hold the
Mobile Button for at least six seconds until the Red and Blue Lights
begin rapidly alternating.
2. Press and hold the Volume Up Button for three seconds.
3. The Red and Blue Lights will flash five times simultaneously and
then the headset will turn off, confirming that Reset was suc-
cessfully completed.
9.8 NOTEWORTHY ISSUES
a. Connecting your scala rider G4 to other scala rider units
To pair your G4 to other scala rider models, please refer to section
9.10 c below.
b. Busy Status (When using a G4 headset)
When attempting an Intercom call with a headset that is already on
a Phone/GPS/Intercom call, you will hear two beeps indicating the
other headset is busy.
15
scala rider
®
G4
™