User guide

7.1c HOT DIAL
Call a pre-programmed phone number automatically at the push
of a button.
1. Congure your G9’s Hot Dial number via the Cardo Community
at http://community.cardosystems.com. See Section 3 for
more details.
2. To call your Hot Dial number, tap the Channel “A” and Channel
“B” buttons simultaneously.
7.2 PAIRING A GPS DEVICE
• Receive GPS navigation instructions
NOTES:
•
Not all Bluetooth GPS devices allow connections to Bluetooth
audio devices. Please consult your GPS User Manual for more
information.
•
If Pairing is not completed within 2 minutes, the scala rider G9 will
return to Standby mode.
1. Turn on your GPS.
2. Verify that your G9 is turned ON and in Standby mode (single
BLUE ash every 3 seconds).
3. Press and hold the Volume Up Button for at least 5 seconds,
until the PURPLE light begins ashing rapidly.
4. Search for Bluetooth device on the GPS device by following the
instructions in the GPS User Manual.
5. Once your GPS lists the scala rider G9 as a discovered device,
select it.
6. If prompted for a PIN or Passkey, enter 0000 (four zeros).
7. Your GPS will conrm that pairing has succeeded and the
scala rider G9 will begin ashing slowly in BLUE.
IMPORTANT: If you wish to use a mobile phone and GPS device with
the scala rider G9, pair the mobile phone directly to the GPS device.
7.3 MUSIC STREAMING VIA A2DP
7.3a PAIRING TO AN A2DP MUSIC PLAYER
• Listen to Stereo Music via A2DP (non-mobile phone
device)
NOTE: The scala rider G9 can also receive audio via the enclosed
cable from non-Bluetooth MP3 Players or audio sources as
described in section 7.4.
1. Turn on the Music Player and make sure that Bluetooth
function is activated.
2. Verify that the scala rider G9 is turned ON and in Standby
mode (single BLUE ash every 3 seconds).
3. Press and hold the Mobile Button for at least 6 seconds. The G9
will rst ash RED. Continue to hold the button until the RED
and BLUE lights begin rapidly alternating.
4. Search for Bluetooth device on the Music Player by following
the device’s instructions.
5. Once your Music Player lists the “scala rider G9” as a
discovered device, select it.
6. If prompted for a PIN or Passkey, enter 0000 (four zeros).
7. The Music Player may conrm that pairing has succeeded, and
the scala rider G9 will begin ashing slowly in BLUE.
English
scala rider
®
G9 / G9 PowerSet | 21 scala rider
®
G9 / G9 PowerSet | 21