User guide

6. USING THE INTERCOM
6.1 MAKING 2WAY INTERCOM CALLS
There are two ways to start an intercom call with devices that are
paired to your scala rider G9.
OPTION 1: Voice Connect (VOX) Intercom Call
Use this for either “One+8” Intercom or 2-way Intercom
Calls (Channel “A” or “B”)
1. Speak any word loudly into the microphone to open the
Intercom channel.
2. When you hear the Voice Command tone, say:
• the name of a ”One+8” Intercom Buddy i.e. “John Smith”
• or say “Call Intercom” to start an intercom call with Rider A
and / or Rider B (subject to who is present)
NOTE: VOX Intercom call with only Rider A or Rider B will end
automatically after 30 seconds of silence.
☛
OPTION 2: Manual Mode
Channel A button
Connect to Rider A
Voice Command button
“One+8“ Intercom
Channel B button
Connect to Rider B
Use this to start an Intercom call with either:
• ”RIDER A” – tap Channel A button
• ”RIDER B” – tap Channel B button
• “One+8” Intercom Buddy – See table below
To end a call tap the respective button again.
“One+8” Intercom
SAY THE NAME:
OR
CHOOSE THE NAME (from your Buddy List):
a. Tap the Voice
Command
button
b. Speak the
name of
the “One+8”
Intercom
Buddy
a. Press and hold the Voice Command button
for 2 seconds
b. The G9 plays the names of all pre-paired
“One+8” Intercom buddies.
c. Once you hear the name of the Buddy
you wish to call, tap the Voice Command
button or speak any word loudly into the
microphone.
To cancel “One+8” Buddy List playback:
Press and hold the Voice Command button for
2 seconds.
NOTE: Voice Command performance may vary based on
environmental conditions including driving speed, helmet type
and ambient noise.
For improved performance of the Voice Command feature,
minimize the wind impact on the microphone by using the large
microphone sponge and closing the visor.
English
scala rider
®
G9 / G9 PowerSet | 17 scala rider
®
G9 / G9 PowerSet | 17