User guide

☛
METHOD 2: Manual Pairing with Channel A / B buttons
1. Check that both G9s are ON and in Standby mode (single BLUE
ash every 3 seconds).
2. Choose a channel to pair the G9 unit (Channel “A” or “B”).
NOTE: Selecting a Channel that is already in use will override the
existing paired device on that Channel with the newly paired device.
3. Press and hold the chosen Channel Button (“A” or “B”) on the
rst G9 for at least 5 seconds until the BLUE or RED LED begins
ashing rapidly, indicating it is in Intercom Pairing mode (see
Table in section 5.2).
4. Immediately repeat Steps 2-3 for the second G9 unit. Both units
will now be in Intercom Pairing mode.
5. After a few seconds, both G9s will show a solid light for
2 seconds, indicating that they are paired, connected and
ready to use.
NOTE: If Pairing is not completed within two minutes, the G9 will
return to Standby mode.
5.2b THREEWAY INTERCOM
If you purchased the scala rider G9 PowerSet, both units are
factory-paired and congured to communicate via their respective
Channel “A” Buttons. To pair a third scala rider G9 use Channel “B”.
To set up three-way intercom conference mode proceed as
follows:
Use Channel “B”
Use Channel “A”
Rider 2
Rider 3
Rider 1
Rider “1” is paired to Rider “2” and also to Rider “3”.
PAIRING THREE SCALA RIDER G9 UNITS
1. Rider 1 pairs their device to Rider 2 using Channel “A” as
described in section 5.2a.
2. Rider 1 pairs their device to Rider 3 using Channel “B” as
described in section 5.2a.
The Three-Way Conference Intercom Pairing is now complete
and ready to use.
IMPORTANT: Three-Way Conference Mode Considerations
During a 3-Way Intercom Conference call with 2 other participants,
Rider 1 will not be able to receive mobile phone calls or GPS
navigation instructions as long as the call is in progress.
English
scala rider
®
G9 / G9 PowerSet | 15 scala rider
®
G9 / G9 PowerSet | 15