User guide

Pairing Online – Cardo Community®
You can nd your friends and add them to your “One+8” Buddy
list via the Cardo Community website at:
http://community.cardosystems.com
5.1d
PAIRED DEVICE INDICATION
Use the Paired Device indication to quickly see which G9 units
within a range of 60ft./20m are your “One+8” Intercom Buddies.
1. Press and hold the Voice Command button for 5 seconds.
2. If your G9 and another nearby G9 are paired as “One+8”
Buddies, both your Purple lights will turn on for 2 seconds.
3. If they aren’t paired as “One+8” Buddies, pair them in seconds
using Flash-Pairing (see Section 5.1c).
5.2 INTERCOM CONFERENCE MODE
Start multi-party conversations using the Channel A and B buttons
on your G9. This mode is suitable for 2, 3 or 4-way calls.
Pairing between scala rider G9s can be done either via Flash-
Pairing
(see below) or by manually pairing the Channel A and B
buttons as described in the following sections.
INTERCOM CHANNELS AND PAIRING LED INDICATION
INTERCOM
CHANNEL
PAIRING / CONNECTION
BUTTON
PAIRING MODE LED
INDICATORS
Channel “A” Channel “A” BUTTON Rapid RED ashing
Channel “B” Channel “B” BUTTON Rapid BLUE ashing
5.2a TWOWAY INTERCOM
If you have purchased the G9 PowerSet, both units are factory-
paired and congured to communicate via their respective
Channel “A” Buttons. If for any reason you have to pair them again,
OR if you purchased a single scala rider G9 and wish to pair with
a second unit to make Intercom calls, proceed as follows:
METHOD 1: Flash-Pairing with Channel A and B
buttons
1. Remove two G9 units from the Audio Kits and verify they are
in Standby Mode (slow single blue ashing).
2. Tap the Channel button (“A” or “B”) on the rst G9 unit and the
purple light begins ashing.
3. Tap the Channel button (“A” or “B”) on the second G9 unit and
the purple light begins ashing.
NOTE: Selecting a Channel that is already in use will override the
existing paired device on that Channel with the newly-paired device.
4. Within 5 seconds of tapping a Channel button, bump the two
G9 units gently against each other and hold them side by side.
CLICK !KLICK!
5. If Flash-Pairing was successful, a purple light appears for 2 seconds.
14 | scala rider
®
G9 / G9 PowerSet 14 | scala rider
®
G9 / G9 PowerSet