Owner`s manual

Cybex Owner’s Manual

7. Remove a screw and washer from the right handle assembly using two 7/32” Allen wrenches.

Right

Handle

Washer

Screw

Pivot Pin Assembly

8. Slide pivot pin assembly out and remove right handle assembly.

9. Rotate right handle assembly 180 degrees.

10.Apply Loctite to threads inside the pivot pin and screw.

11.Place right handle assembly in position and slide pivot pin assembly back in place.

12.Install the screw and washer to the right handle assembly using two 7/32” Allen wrenches.

Install the left linkage rod

1. Pivot left handle assembly up and slide left linkage rod onto left arm.

Left Linkage

Rod

Linkage Rod

Cap

Screw

Washer

Left Arm

Flange

Spacer

Loctite

2. Place a drop of Loctite onto the screw.

3. Install the screw, washer, linkage rod cap, and flange spacer using a 3/16” Allen wrench.

4. Tighten screw to a minimum of 90 in/lbs.