Owner`s manual

Cybex Arc Trainer 625A/625AT Owner’s Manual
35
Install the left handle assembly
1. Position the left handle assembly in the correct position on the left side where the right handle
assembly was removed in the previous procedure.
2. Apply Loctite to threads inside the pivot pin and screw removed in the previous procedure.
3. Place left handle assembly in position and slide pivot pin assembly back in place.
4. Install the screw and washer to the left handle assembly using two 7/32” Allen wrenches.
5. Pivot left handle assembly up and slide left linkage rod onto left arm.
Left Linkage
Rod
Linkage Rod
Cap
Screw
Washer
Left Arm
Flange
Spacer
Loctite
6. Place a drop of Loctite onto the screw.
7. Install the screw, washer, linkage rod cap, and flange spacer using a 3/16” Allen wrench.
8. Tighten screw to a minimum of 90 in/lbs.
Install right handle assembly
1. Position the right handle assembly in the correct position on the right side where the left
handle assembly was removed in the previous procedure.
2. Apply Loctite to threads inside the pivot pin and screw removed in the previous procedure.
3. Place right handle assembly in position and slide pivot pin assembly back in place.
4. Install the screw and washer to the right handle assembly using two 7/32” Allen wrenches.