Specifications

2
).34!,,!4)/.
5NPACK
Carefully unpack the scale and commodity tray. Remove the protective film from the front and
rear displays. Make certain that no sign of damage to the instrument is visible. Should
evidence of damage be found, the carrier should be contacted at once. Make certain to keep
the carton and packing material should return shipment or storage of the instrument become
necessary.
3HIPPING3CREWS
The load cell is protected from shipping damage by two (2) shipping screws through the top
housing and one (1) shipping thumb screw located on the bottom of the scale (see figure).
Remove the two (2) shipping screws, the thumb screw and the warning label before using the
scale. Retain the two (2) shipping screws and the thumb screw to be re-installed before
transporting or shipping the scale. Note: Only hand tighten the thumb screw on the bottom of
the scale and do not over-tighten the two (2) shipping screws through the top housing.
#!54)/.$ONOTPOSITIONTHESCALEONITSTOPTURNUPSIDEDOWNTOREMOVE
THESHIPPINGTHUMBSCREW)NSTEADPOSITIONTHESCALEONITSBACKTOREMOVE
THETHUMBSCREW

0LACEMENT
Place the scale on a stable, vibration-free location away from direct sunlight and away from
any rapid moving air source. Make certain the power cord is stored out of the way of normal
traffic.
#!54)/.$/./4PLACETHESCALEONANYUNSTABLECARTSTANDORTABLE4HE
SCALEMAYFALLCAUSINGINJURYTOTHEOPERATORANDSERIOUSLYDAMAGETHEUNITOR
PROPEROPERATIONOFTHESCALEMAYBEINHIBITED
,EVEL3CALE
Before mounting the commodity tray onto the scale, level the scale if necessary by adjusting
the four legs on scale bottom, up or down, until the bubble in the level gage located on the
scale housing is centered as shown in the figure above. After level is achieved, lock legs in
place by tightening lock nuts on legs against the scale bottom.