Specifications

20
%22/2-%33!'%3
".3a
a
Indicates that the scale has never been setup and calibrated or has
been interrupted during the setup and calibration sequence.
::"a
a
Indicates a faulty component or broken wire in the analog circuitry of the
instrument.
."a
a
Will appear whenever the program cannot write data into the system
memory (setup and calibration is in progress).
a
A7=Aa
a
Will appear in the weight display whenever a net weight exceeds -9999
(4 digits negative).
$%a
a
Indicates the scale weight capacity has been exceeded.
(1+<3a
a
Indicates motion on the commodity tray during sampling. This message
may occur when:
1. The 02).4key is pressed.
2. The :%2/key is pressed.
3. The 4!2%key is pressed (to enter current weight as push
button tare).
::7:a
a
Indicates an incorrect key depression. It is accompanied by a long tone
(beep).
"74a
a
Indicates there is insufficient deadload for the scale to zero.
(1"74a
Indicates there is too much deadload for the scale to zero.
A7=Aa
a
The error message A7=A(overflow) will appear in either the unit price
or total price displays whenever the amount to display exceeds 99999
for unit price or 999999 for total price. A7=Awill also appear in the
weight window when an attempt is made to tare a weight greater than
9999.
A.1<Aa
a
The error message A.1<A(interval) will appear in the unit price display
whenever the keyboard tare weight division value isn’t the same as the
scale division value.
For example, a PC-20 (15 lb x .005 lb) will display A.1<Aif you attempt
to enter 1.003 for the tare weight.
A<:"a
The error message A<:"A(zero tracking limit) will appear in the unit
display whenever the :%2/key is pressed with the weight outside the
scale zero weight range. NOTE! Only 4% of scale capacity can be
zeroed.
+:7=a
a
The error message +:7(serial overflow) will appear in the total price
display whenever the scale’s serial buffer is overrun during
communication.
17%:<a
a
The error message 17%:<(no printer) will appear when attempting to
print without a “handshake cable” if the value for Prt= is a 2 or 3.
+=.1,a
a
The message +=.1,(saving) is displayed while downloading a
nControl ticket.