Specifications
19
3%4502%6)%7-/$%
The SETUP REVIEW MODE allows several operational parameters to be reviewed and
changed as necessary without having to enter the setup and calibration mode. The
parameters in the setup review will be processed in the following sequence:
• (4?a Select baud rate for serial output.
• %2:?aa Parity setting
• %:<?aa Label printer selection
• +40>?a Select delay
• .4?a a Store Name/ID
• 2:8?a Enable or Disable bar code printing
• 051?a Select bar code prefix limit
• 32:9?a Enter bar code prefix
• #.1?aa Set the minutes portion of the time
• 7(:?a Set the hours portion of the time
• >?aa Set the day of the month
• #71?aa Set the month of the year
• )&?a Set the year
To enter the setup review mode:
1. Turn the scale off.
2. Press and hold the %.4%2key, then press the /.key.
3. The display will show +<(% the model number and software revision momentarily,
then change to the 32=4?, the selection to set the baud rate for the serial output.
4. Refer to the instructions listed in the Setup and Calibration section of this manual for
information on how to change these parameters.
2%#/--%.$%$3%!,).'
To prevent access to interior components, seal the indicator as follows:
1. Bend tab over end cap retaining screw as shown. Press the tab down against the
screw head. Make certain both screws are tightened securely before proceeding.
2. Thread the sealing wire through the hole in the tabs as shown. Pull the wire tight and
install the lead seal. Neither screw can be removed without damaging the seal.