Specifications
15
ERROR MESSAGES
Indicates that the scale has never been setup and calibrated or has been
interrupted during the setup and calibration sequence.
Indicates a faulty component or broken wire in the analog circuitry of the
instrument.
Will appear whenever the program cannot write data into the system memory
(setup and calibration is in progress).
Will appear in the weight display whenever a net weight exceeds -9999 (4 digits
negative).
Indicates the scale weight capacity (999,999) has been exceeded.
Indicates motion on the commodity tray during sampling. This message may
occur when:
1. The PRINT key is pressed.
2. The ZERO key is pressed.
Indicates an incorrect key depression. It is accompanied by a long tone (beep).
Indicates there is insufficient deadload for the scale to zero.
Indicates there is too much deadload for the scale to zero.
The error message -ouF- (overflow) will appear in either the unit price or total
price displays whenever the amount to display exceeds 99999 for unit price or
999999 for total price. -ouF- will also appear in the weight window when an
attempt is made to tare a weight greater than 9999.
The error message -int- (interval) will appear in the unit price display whenever
the keyboard tare weight division value isn’t the same as the scale ivision value.
For example, a PC-20 (15 lb x .005 lb) will display -int- if you attempt to enter
1.003 for the tare weight.
The error message -trL- (zero tracking limit) will appear in the unit display
whenever the ZERO key is pressed with the weight outside the scale zero
weight range. NOTE: Only 4% of scale capacity can be zeroed.
The error message SErovF (serial overflow) will appear in the total price display
whenever the scale’s serial buffer is overrun during communication.
The error message noPrt (no printer) will appear when attempting to print
without a “handshake cable” if the value for Prt= is a 2 or 3.
The message SAving (saving) is displayed while downloading a Visual Print
ticket.
FAiL2
OCAP
CALib
ErrAL
UnStb
LoAd
-ouF-
UnLod
Error
-ouF-
-int-
3. The TARE key is pressed (to enter
current weight as push button tare).
-trL-
SErouF
noPrt
SAuing