Owner`s manual

ManualsBrandsCardinal ManualsDomestic AppliancesDetecto PZ3000 Series

8528-M372-O1 Rev E  PZ3000 Series

SETUP AND CALIBRATION, CONT.

FLT= (Digital Filter Level Selection)

Your scale will arrive with factory filter settings of 0 = Minimal (PZ3060 will be 2 = Heavy).

Please check with Tech Support before changing filter level, break range and sample rate.

Press ZERO key to show current setting. If value displayed is acceptable, press ZERO key

again to save it. Otherwise, use UNITS key to step through selections for a new value and

then press ZERO key to save it. Allowable values are:

0 = Minimal Filter 2 = Heavy Filter 1 = Moderate Filter 3 = Custom Filter

NOTE: If 3 = Custom Filtering is selected, three additional prompts will be displayed.

FLTLUL= (Filter Level)

Press ZERO key to show current setting. If value displayed is acceptable, press ZERO key

again to save it. Otherwise, use UNITS key to step through selections for a new value and

then press ZERO key to save it. Allowable values are 1

(least amount of filtering) to 99

(greatest amount of filtering).

BR = (Break Range)

Press ZERO key to show current setting. If value displayed is acceptable, press ZERO key

again to save it. Otherwise, use UNITS key to step through selections for a new value and

then press ZERO key to save it. Allowable values are 1

to 99 which correspond to the number

of division changes to break out of filtering.

SR= (Sample Rate)

Press ZERO key to show current setting. If value displayed is acceptable, press ZERO key

again to save it. Otherwise, use UNITS key to step through selections for a new value and

then press ZERO key to save it. Allowable values are a minimum of 1

sample per second to a

maximum of 16

samples per second in one sample per second intervals.

UNITS= (Weighing Units)

Press ZERO key to show current setting. If value displayed is acceptable, press ZERO key

again to save it. Otherwise, use UNITS key to step through selections for a new value and

then press ZERO key to save it. Allowable values are:

1 = Pounds Only 4 = Kilograms

2 = Ounces Only 5 = Pounds/Ounces with Decimal Point

3 = Pounds/Ounces with Fraction 6 = Grams

NOTE: If 3 = Pounds/Ounce with Fraction is selected, an additional prompt ( Fract= ) will

be displayed. In addition, the int (Interval Setting) and dPP (Decimal Point Position) will be

skipped.

FRACT= (Fraction Interval)

Press ZERO key to show current setting. If value displayed is acceptable, press ZERO key

again to save it. Otherwise, use UNITS key to step through selections for a new value and

then press ZERO key to save it. Allowable values are:

0 = No Fraction 2 = 1/2 4 = 1/4 8 = 1/8

int= (Interval Setting)

With the display showing int=, press the ZERO key to show the current setting. If the value

displayed is acceptable, press the ZERO key again to save it. Otherwise, use the UNITS key

to step through the selections for a new value. When the desired value is displayed, press the

ZERO key to save it. Allowable values are: 1, 2, or 5.