Owner`s manual

8528-M372-O1 Rev E  PZ3000 Series

SETUP AND CALIBRATION

Your PZ3000 Ingredient scale has been pre-configured at the factory and should not require

configuration for use in most applications. In the event that the factory settings do not meet the

requirements of your application, the following describes the steps to configure the scale.

IMPORTANT! The display and scale base are a matched pair. Do not switch

them (refer to S/N tags) without recalibration.

To Begin Setup and Calibration:

1. Press and hold the ZERO key.

2. Press and hold the ON/OFF key until the scale display shows 3000.

3. Release the ON/OFF key.

4. The display will change to show photoI=.

5. Release the ZERO key to enter the setup mode.

During setup and calibration it will be necessary to enter data using the scale’s keyboard.

Pressing the ZERO key will show the current value of a setting. Pressing the ZERO key

again will save the displayed setting value and advance to the next prompt. To change a

setting, press the UNITS key to "toggle" between the different available values. On

settings with 2 digit values, press the ON/OFF key to advanced to the next position. Note

that the blinking character is the cursor location of the value to be changed. To exit setup,

press the ON/OFF key at any prompt.

PhotoI= (LITE WAY Photo Eye)

With the display showing photoI=, press the ZERO key to show the current setting. If the

value displayed is acceptable, press the ZERO key again to save it. Otherwise, use the

UNITS key to step through the selections for a new value. When the desired value is

displayed, press the ZERO key to save it. Allowable values are:

0 = Wavy Zero Turned Off

1 = Wavy Zero intensity set to 0 to 2 inches

2 = Wavy Zero intensity set to 6 inches maximum

BAC LT= (Back Light)

With the display showing bac lt=, press the ZERO key to show the current setting. If the

value displayed is acceptable, press the ZERO key again to save it. Otherwise, use the

UNITS key to step through the selections for a new value. When the desired value is

displayed, press the ZERO key to save it. Allowable values are:

0 = Back Light Turned Off

1 = Back Light set to continuously on

2 = Back Light comes on after key press or change in weight

BEEP= (Beeper)

Press ZERO key to show current setting. If value displayed is acceptable, press ZERO key

again to save it. Otherwise, use UNITS key to step through selections for a new value and

then press ZERO key to save it. Allowable values are:

0 = Disable Beeper 1 = Enable Beeper