Owner`s manual

PD300

Quick Start

Step 1. Once the scale is assembled, place it on the floor.

Step 2. Carefully lay the scale over on its side with the edge of the display resting on the

floor and then locate the battery access cover on the bottom of the scale.

Step 3. Remove the cover, install six (6) “AA” size batteries

and then replace the cover.

Step 4. Return the scale to the upright, normal operating position and make sure it is level.

Step 5. Press the ON/OFF key to turn the scale on.

Step 6. When the display is showing 0.0, have to patient step on the scale.

Step 7. Wait a few seconds for the weight to display and then read the patient’s weight.

Step 8. Patient may now step off scale.

Step 9. Press the ON/OFF key to turn the scale off.

See page 17 for detailed instructions on installing the batteries.

For complete Operation and Setup instructions, refer to pages 19 to 27.

0044-M340-O1 y ProDoc Series

Page 12