Owner`s manual

Assembly
Installing the Column and Display, Cont.
9. Remove the scale from the desk
or table and place it upright on
the floor.
10. Connect the plug end of the
connection cable to the preset
cable from the display and then
insert the cable into the column.
11. Locate the two (2) tabs (one on each side)
on the connector case and the two (2) slots
in the bottom of the display.
11.1. Align the tabs with the slots and
press together until the tabs on the
connector case snap into the slots in
the bottom of the display.
Tab
Connector
Case
Display
Bottom
Figure No. 17
Display
Preset
Cable
Tab
Connection
Cable
PD300
Figure No. 16
PD300
Slots
Tab
PD300
Connector
Case
Screws
12. Secure the display to the connector case with the
supplied three (3) screws.
Figure No. 18
0044-M340-O1 y ProDoc Series
Page 11