Owner`s manual

PD300
Assembly
Installing the Column and Display, Cont.
2. Insert the socket end of the connection
cable into the column connector case.
Feed cable through entire length of column.
Refer to Figure No. 10 to insure correct
connector on each end of column.
Figure No. 10
Column
Connector
Case
Connection
Cable
Connection
Cable
Preset
Cable
3. Place the scale on a desk or table
4. Connect the socket end of the connection cable to
the preset cable in the scale base.
Figure No. 11
5. Align the long slot in the column with the slot in the column holder and then insert the column
into the hole on the column holder.
NOTE! Make sure the preset cable passes through the slots in both the column (the long slot)
and the column holder.
Figure No. 12
Preset
Cable
Slot in
Column
Holder
Column
Preset
Cable
Slot in
Column
0044-M340-O1 y ProDoc Series
Page 9