Operating instructions

8525-M041-O1 Rev L  8430 Series
7
HEIGHT ROD INSTRUCTIONS
Height Rod Hole Location
Please check the Height Rod hole
locations before installing the
Height Rod.
 Some scales may require
holes to be drilled.
 Please follow the
measurements for drilling holes
if necessary.
 After holes have been drilled,
please follow installation
instructions.
Height Rod Installation
1. Remove the height rod, height rod
brackets and hardware pack from
the cardboard insert.
2. Attach the height rod brackets to
the height rod using the four
screws, lock washers and nuts
enclosed in the hardware pack.
Tighten all four screws.
IMPORTANT!
Measure from bottom of
column, not floor or scale
base.
29
47/64”
(75.5 cm)
5
15/64”
(13.3 cm)
9/64”
(3.5mm)
diameter holes,
1” (25.4mm) from
center of column
to center of hole
Height Rod
Height Rod
Bracket
2in (51mm)