Operating instructions

1930-M458-O1 Rev-E  Waist-High 685X Series

UNPACKING INSTRUCTIONS

 Remove staples or cut along bottom of carton. Lift carton off pallet.

 Check for any damage incurred in shipping. If scale has been damaged, place a claim

with the carrier. It is the responsibility of the purchaser to file all claims for any damages

or loss incurred during transit. Use the original carton and shipping material to return

the scale.

 Cut packing straps securing scale to pallet.

 To remove scale from pallet, at the back of the scale lift up with equal force from the

column and at the platform base near the wheels on the scale. Set gently on floor.

 Remove all plastic wrapping, foam fillers and cardboard material from the scale.

 Remove and unpack the power supply and cord, if the scale was ordered with this

option.

 Install the batteries or if ordered with the scale, plug the small connector end of the

power supply cord into the power jack located on the back of the indicator, then plug the

power supply module into an appropriate power receptacle. NOTE! DO NOT

connect a

power supply to the indicator if Alkaline batteries are installed.

 Install the indicator on the scale bracket on the column and then connect the load cell

cable to the indicator.

NOTE: For additional information on installing the batteries (or the power supply

module), mounting the indicator on the scale bracket and connecting the load cell cable;

Refer to the 750 Weight Indicator Owner’s Manual (8555-M483-O1) for the 6855,

6855KGEU, 6856 or 6856KGEU

Refer to the MedVue MV1 Owner’s Manual (8555-M512-O1) for the 6854DHR or

6857DHR.

Refer to the MedVue MV2 Owner’s Manual (8555-0530-0M) for the 6854KGEUDHR

or 6857KGEUDHR

CARE AND CLEANING OF SCALE

 DO NOT subject the platform to sudden shocks.

 DO NOT submerge indicator in water, pour or spray water directly on indicator.

 DO NOT use acetone, thinner or other volatile solvents for cleaning.

 DO NOT expose scale to temperature extremes.

 DO NOT place scale in front of heating/cooling vents.

 DO NOT place scale in an area where it might be exposed to moisture.

 DO clean the indicator with a damp soft cloth and mild non-abrasive detergent.

 DO remove power before cleaning with a damp cloth.

 DO provide clean AC power and adequate protection against lightning damage.

 DO keep the surroundings clear to provide clean and adequate air circulation.